BROSA Betty Rocking Chair User manual

ASSEMBLY GUIDE
Betty Rocking Chair
v1.0

Components
Upon unpacking your rocking chair from it’s delivery box, you should have
the separate pieces shown below. Follow the steps on the next pages to
assemble your new rocking chair.
Chair body x 1
A x 4 B x 4 C x 4 D x 2 E x 1
Hardware
What you need
Leg x 2 Support bar x 1
12
3

Step 1
A x 4
B x 4
C x 4
E x 1
Align a leg (2) to the underside of the chair body (1)
so that the screw holes are overlapping. Fit a spring
washer (C) then a at washer (B) to a bolt (A). Insert
the bolt into the hole and turn the bolt with the allen
key (E) until it is secure but do not tighten yet.
Repeat for the other leg.
E
A
C
B

Step 2 Fit the tenons on both ends of the support bar to the
mortises on the legs. Make sure that the screw holes
on the support bar are facing the ground when
standing upright. Insert the metal thread screw (D)
into the hole and tighten with a phillips head screw-
driver.
D x 2
D

Step 3
Step 4
Use the allen key and phillips head screwdriver to
tighten all the bolts and screws.
Gently lift the chair and place upright on a level
surface. Enjoy your new rocking chair!