BROSA Evelyn 3-Seater Chaise User manual

ASSEMBLY GUIDE
Evelyn 3-Seater Chaise
v1.0

Components
Upon unpacking your chaise from it’s delivery box, you should have two
separate components (two bodies of the chaise - left body and right body).
Additional components are packed inside the bodies, you will learn how to
access and utilise these components in the next steps.
Starting with the left body of the chaise, turn it so that the underside is facing
you. Follow the coloured string to the component compartment. Unzip this
and take out the additional components, then zip it back up.
Chaise bodies x 2
Left body Right body
Unpacking
A x 4 (Leg)
B x 4 (Bolt)
C x 4 (Washer)
D x 1 (Allen Key)
E x 1 (Center Leg)

Step 1 Align a leg (A) so that the screw slot is facing inward.
Fit a washer (C) to a bolt (B) and use them to t the
leg onto the body of the chaise. Turn the bolt with the
allen key (D) until it is secure but do not tighten yet.
Repeat for all four legs.
Step 2 Screw the center leg (E) it into it’s corresponding slot
in the middle of the sofa and tighten.
D x 1
C x 4
B x 4
A x 4
E x 1
A
D B C
E

Step 3 Lift the chaise o the ground and turn it right side
up while being careful not to put any pressure on the
legs while you turn the chaise.
D x 1
Step 4 Place the chaise on a at surface, then sit on the
chaise and shift your weight around until the legs
are level and the chaise does not rock. en use the
allen key (D) to tighten all the bolts. Now that is the
left body of your chaise complete.

Components
We are now moving onto the assembly of the second component, the right
body of your 3 seater chaise.
With the right body of the chaise, turn it so that the underside is facing you.
Follow the coloured string to the component compartment. Unzip this and
take out the additional components, then zip it back up.
Right body
Unpacking
A x 4 (Leg)
B x 4 (Bolt)
C x 4 (Washer)
D x 1 (Allen Key)

Lift the chaise o the ground and turn it right side
up while being careful not to put any pressure on the
legs while you turn the chaise.
Step 1 Align a leg (A) so that the screw slot is facing inward.
Fit a washer (C) to a bolt (B) and use them to t the
leg onto the body of the chaise. Turn the bolt with the
allen key (D) until it is secure but do not tighten yet.
Repeat for all four legs.
Step 2
D x 1
C x 4
B x 4
A x 4
A
D
B
C

Place the chaise on a at surface, then sit on the
chaise and shift your weight around until the legs
are level and the chaise does not rock. en use the
allen key (D) to tighten all the bolts. Now that is the
right body of your chaise complete.
Step 3
D x 1
Step 4 ere are two brackets on the joining sides of the
two components. Slot the brackets into each other
to join the chaise together. Enjoy your new chaise!

Enjoy your new chaise!
Step 5