BROSA Sondra Sofa Bed User manual

ASSEMBLY GUIDE
Sondra Sofa Bed
v1.0

Components
Upon unpacking your sofa bed from it’s delivery box, you should have one
single component (the body of the sofa bed). Additional components are
packed inside the body, you will learn how to access and utilise these
components in the next steps.
Follow the zip to the component compartment. Unzip the bottom fabric and
take out the additional components. Keep the bottom fabric open.
Unpacking
1
23

Hardware
You will need
D x 8 F x 1
C x 8
H x 1E x 8 G x 4
A x 2 B x 2

Step 1 1.1 Insert and tighten the threaded rods (C) into the
holes on armrests (2),(3).
1.2 Turn the sofa bed body so that the underside is
facing you. Fit armrests into corresponding holes on
sides of the sofa bed body.
1.3 Fit a washer (D) and hex nut (E) onto a rod (C) of
armrests from Step 1.2.Screw the hex nut using the
socket wrench (F) and repeat for the other bolts to
secure the armrests in place. Zip the bottom fabric
back when all is done.
C x 8
Step 1.1
Step 1.2
D x 8
E x 8
F x 1
Step 1.3
C
FED
2
3
3

Step 2 Fit a bolt (G) into a front leg (A). With the sofa bed
laid on its side, screw the bolt into the hole towards
the front of the sofa bed using allen key (H). Repeat
for the other front leg.
A x 2
G x 2
H x 1
Step 3 Fit a bolt (G) into a rear leg (B). Align the leg with the
holes towards the back of the sofa bed. Screw the
bolt using the allen key (H). Repeat for the other rear
leg.
B x 2
G x 2
H x 1
AG
H
B
G
H

Step 4 4.1 Unzip the back fabric and pull the support legs
out. Slightly push the back forward and then put it
down gently then you will get a bed position.
4.2 Push the back upwards until it is steady and fold
the support legs back into the back fabric then you
will get a sofa position again.
Enjoy your new sofa bed!
1
1
2
3
Step 4.1
2
2
Step 4.2
1