BROSA Mia User manual

ASSEMBLY GUIDE
Mia Extendable Dining Table
v1.0

Components
Upon unpacking your dining table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dining table.
Hex nut
M8 x 13mm
Cross dowel
M8 x 12 x 60mm
Threaded bolt
M8 x 80mm
Large washer
8.4 x 17 x 1.6mm
Lock washer
8.4 x 2mm
Spanner
Table top x 1
x 4
x 1
x 4 x 8
x 8
x 8
x 8
1Corovin storage bag x 1
Leaf x 1
3
Leg
24
A
B
C
E
F
D
Item Qty.Description Item Qty.Description

Step 1
A x 4
B x 8
1.1 Insert cross dowels (A) into the hole on top of each
leg (2) as shown. Ensure the horizontal marking on
each tting (A) is facing down.
1.2 Screw threaded bolts (B) into ttings (A) that are
concealed in leg (2) as shown. Continue to
re-tighten until bolts (B) are securely fastened.
Step 1.1
Step 1.2

Step 2 Extend both sides of the main table top completely
then remove the corovin storage bag (3) as shown.

Step 3 3.1 Attach each leg (2) into place by inserting bolts (B)
through the pre-drilled holes of each metal corner
bracket as shown.
3.2 Insert in order the at washer (C), lock washer (D)
and hex nut (E) onto threaded bolt (B) on leg (2) and
tighten using spanner (F) until they are securely
fastened. Repeat on remaining legs.
3.3 Lock the latch lock.
C x 8
D x 8
E x 8
F x 1
Step 3.2
Step 3.1
Step 3.3
Step 3.1
Step 3.2
Step 3.3

Step 4 Important: Ensure you have already locked the latch
lock in Step 2 before righting the table.
Note: When moving the table, remove leaf, close table
top and lock the latch lock, then move by gripping or
lifting the legs or underframe.
Caution: is product is heavy, with help of assistant
stand the table upright.
Step 5 Place storage bag (3) and leaf (4) onto at surface.
Remove leaf (4) as shown.

Step 6 Unlock the latch lock that were locked in Step 3.
Extend both sides of the main table tops completely.
Place leaf (4) over the side aprons as shown.
Step 7 Push ends of table inwards until no gap is visible.
Ensure the metal pins are aligned to the holes on the
main table tops and the leaf before closing the table.
Note: ensure you have locked both locking devices
under the table after closing the table.

Step 8
Step 9 Place the leaf (4) into corovin bag as (3) shown.
Remove the leaf. Unlock the latch lock that were
locked in Step 6. Extend both sides of the main table
tops completely then remove the leaf (4) as shown.

Step 10 Put the corovin storage bag (4) onto wood support
storage frame under table as shown then close the
table by pushing both sides of the main table tops
inwards until no gap visible. Ensure the metal pins are
alligned to the holes on the main table tops before
closing the table. Note: ensure you have locked both
locking devices under the table after closing the table.
Assembly is complete!