CREE LIGHTING SmartCast Touchscreen Control User manual

SmartCast®Touchscreen Control
SmartCast®Touchscreen Control with Dynamic Lighting
LPN00657X0001A0_B
1 of 2
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
1
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l’alimentation avant
l’installation.
2. Must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and
requirements, consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n’êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualié.
3. Indoor use only.
Pour usage interieur seulement.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
Installation of the provided recessed wall
box, battery modulator, and wall-mount kit
are required to complete the installation of
the SmartCast®Touchscreen Control.
See Figure 1.
SMARTCAST®TOUCHSCREEN
CONTROL KIT INCLUDES:
• (1)- Tablet
• (1)- 90 degree USB-C to
USB-C cable
• (1) - Wall-mount kit
• (1)- Recessed wall box
• (1)- Battery modulator
REQUIRED BY CUSTOMER:
• 120V outlet
• Single gang wall plate
Wall-Mount Kit
Recessed Wall Box
Battery
Modulator
Wall-Mount Kit, Recessed
Wall Box, & Battery
Module
Tablet

LPN00657X0001A0_B
2 of 2
www.creelighting.com
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree®and the Cree logo are
registered trademarks and the Cree SmartCast Technology logo is a trademark of Cree, Inc. SmartCast®, is a registered
trademark of Cree Lighting, A company of IDEAL INDUSTRIES.
2
TOP VIEW BOTTOM VIEW
USB-C Port, Marked Mobile
Device (Going Into The
Tablet)
USB-C Port, Marked
Power Adapter (Going
To The Tablet’s Power
Adapter)
INSTALLATION
STEP 1:
Install the Recessed Wall Box in a landscape orientation
per the included installation instructions.
NOTE: Do not remove the audio/video/data knockouts from
the Recessed Wall Box.
STEP 2:
Install the Wall-Mount Kit over the Recessed Wall Box per
the included installation instructions.
STEP 3:
Plug the Tablet adapter into the outlet.
STEP 4:
Connect the Battery Modulator to the Tablet adapter and
the Tablet. See Figure 2.
STEP 5:
After performing OneButtonTM Setup on the lighting
network and configuring the SmartCast®Wireless
Gateway with WiFi, power on and setup the SmartCast®
Touchscreen by following the on-screen instructions. For
setup and troubleshooting information please refer to the
resources available at - https://www.creelighting.com/
touchscreen-help.