DV8 OFFROAD CCT2-01 User manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
PRODUCT
INSTALLATION MANUAL
TUNDRA CENTER CONSOLE
AND BRIDGE
3RD GEN (2022+) TOYOTA TUNDRA
CCT2-01
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
-Nutsert Tool (Optional)
-Drill
-11/32” Drill Bit
-Ratchet
-4mm Allen Bit
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Novice/Intermediate
- 1 (you) to 2 persons
Little skill level required, you can
easily install it by yourself however,
additional help will be useful
-1.5 Hours
Time to install this should only
take about an half an hour.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
855-680-9595
NEED HELP?

Assemble the bridge and side mounts using
a 4mm allen bit and provided M6 hardware..
Fit the center console into place.
When you are satised with the tment,
mark the mounting holes with a sharpie and
remove/disassemble the center console and
bridge.
Note: An extra pair of hands to hold everything in
place will make this process easier.
INSTALLATION MANUAL
NEED HELP? 855-680-9595
- (12) M6x14 Allen Head
- (12) M6 Flat Washer
- (12) M6 Serrated Nuts
- (12) M6x14 Nutserts
HARDWARE INCLUDED
Begin by unpacking all items and inspect-
ing for missing pieces or damage. If you
have any concerns, please contact the com-
pany the product was purchased from.
STEP 1
STEP 2

If you installed nutserts, drop the center
console and bridge into place and secure
using provided M6 hardware and a 4mm
allen bit.
If you did not use nutserts, press the M6
hardware through the mounting holes to
hold it in place.
Pull back on the center console trim to
install the serrated nuts. Use a 4mm allen
bit while applying pressure with your hand
on the serrated nut until “catches” and is
secured.
(Optional) You may choose to install the
provided M6 nutserts with a nutsert tool for
an easier installation.
We do highly recommend using a nutsert
on the driver side front upper mounting
hole due to how to difcult it is to reach
back with a nut.
Use an 11/32” drill bit to drill out the marked
mounting positions.
Note: Drill accurately and carefully to avoid scuff-
ing the trim unnecessarily. Do not drill any further
than the center console trim. It may be helpful to
pull the center console trim back slightly to en-
sure you are drilling only through center console
trim.
INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 3
STEP 3
STEP 4

Double check tment and all hardware is
secure. Congratulations, you are nished
with the install of the 22+ Toyota Tundra
Center Console and Bridge.
INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 4