Fisher-Price KICK'N CRAWL Aquarium H8094 User manual

Crawl-through Aquarium
H8094
Instructions
www.fisher-price.com
Kick'n Crawl™
Aquarium
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Tool required for battery assembly: Phillips Screwdriver (not included).
Musical fish requires three button cell (LR44) alkaline batteries (or equivalent) (included).
Tummy-time Play
Overhead Gym
1
2
3

2
To prevent entanglement injury, never
place gym in a crib or playpen.
Never add strings, ties or other products to this item.
WARNING
Consumer Information
Visit us on line at www.service.fisher-price.com
Call Fisher-Price®Consumer Relations, toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470. Write to us at: Fisher-Price®Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.

3
Overhead Gym Assembly
Tubes
Support
Support
Slots
Quilt
Straps
• Place the quilt, print side up, on a flat surface.
• Fit the two straps on each side of the quilt down through the slots in the
supports. Make sure the tab at the end of each strap forms a “T” under the
support. Pull up on the quilt to be sure it is secure to the supports.
• Fit the two, small fastener straps on
each end of the tubes through the
slots inside the circular openings in
the supports. Fasten the straps to
secure the tubes to the supports.
• Fasten the activity toys to the straps
on the arch.
• Squeeze the stem to inflate the ball.
Now, fasten the ball to the strap on
the other arch.
Fastener Straps
Fastener Straps
Bottom View

Tummy Time Fun
FOLD
INWARD
• Attach the activity toy straps to the fasteners on the quilt. Attach the ball to the
tube strap.
4
Activity Toy
Ball
Quilt
• Assemble this toy as an overhead gym.
• Locate the end of the quilt with the strap.
• Fold the end of the quilt inward.
• Press to attach the fasteners.
Strap
Fastener
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA H8094a-0920

5
Crawl-Through Aquarium Assembly
Tube
Support
Slots
Plastic Tab
Sleeves
Fastener Straps
• Slide the tubes through the sleeves in each side of the quilt.
• Position the supports so that the side with the slots faces inward.
• Fit the two, small fastener straps on each end of the tubes through the slots
inside the circular openings in the supports. Fasten the straps to secure the
tubes to the supports.
• Fit the plastic tabs at the corners of the quilt into the slots in the supports.
• Attach the activity toys and the ball to the fasteners on the sleeves.

6
Battery Compartment Door
When sounds from this toy become faint or stop, it is time for an adult to change
the batteries!
• Locate the battery compartment on the side of the musical fish.
• Loosen the screw in the battery compartment door with a Phillips screwdriver.
Remove the battery compartment door. Throw exhausted batteries away.
• Insert three, new, button cell (LR44) alkaline batteries, as indicated inside the
battery compartment.
• Replace the battery compartment door and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
Battery Replacement
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a
chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated on the battery compartment door.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
1.5V x 3
LR44 or Equivalent
SHOWN ACTUAL SIZE
For best results, use
only alkaline batteries,
for longer battery life.

PRESS
7
Recycle Information (U.S.A. ONLY)
If your product contains replaceable button cell batteries, please remove and
recycle the battery(ies). If the batteries in your product are not replaceable,
please recycle your product.
• Visit your nearest recycling center. For the location of the nearest recycling
center, visit us online at www.service.mattel.com.
• If a recycling center is not available in your area, contact us for a pre-paid
mailing label. Visit us online at www.service.mattel.com or call us toll-free,
1-800-432-5437.
Fun Music and Sound Effects
• Press the button on the side of the musical fish to hear music and sound effects.

8
• Machine-wash the play quilt in cold water on the gentle cycle. DO NOT use
bleach. Tumble dry on low heat.
• Surface wash the tubes, activity toys and supports with a mild cleaning solution.
• This toy has no consumer serviceable parts. Please do not take this toy apart.
Care
Carry-Along
• Place the play quilt print side up on a flat surface.
• Attach the activity toys to the straps on the sides of the play quilt and place
the toys on top of the quilt.
• Locate the fastener strap at one end of the play quilt. Place the supports and
tubes at the opposite end of the play quilt and roll the play quilt from end
to end.
• Fit the fastener strap through the loop on the outside of the play quilt and
fasten to close.
Fastener Strap
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303;
www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.