Friant LUNE FCTTB User manual

Parts List
Installation Steps
IMPORTANT NOTES:
• 2 Person installation
• Please Read Instructions Before Use
• Place all components on a clean and smooth surface during installation
• Loosely secure screws and bolts until the table is completely assembled,
then tighten
Step 1: Attach casters Jto base kit N
PART# NAME QUANTITY
A Allen Wrench 1
B Set Screw 8
C Wood Screw
Ø4.2*20
7
G Worksurface Bolt
M6*20
8
H Bar Support 2
I Adjustable Leaver Cap 1
J Locking Caster 4
O Cable Clips 2
P Telescopic Support Bar 1
Q Telescopic Connector 2
L Worktop 1
M Modesty 1
N Base Kit 1
Step 2: Attach telescopic support bar Pto base kit Nusing (2) bar supports H and (2)
telescopic connectors Q.
For FCTTB-MOD only: Position modesty panel M
within the modesty brackets of base kit N
Step 3: Secure the telescopic support bar Pto the base kit Nusing (8) set screws B.
Tighten set screws.
For FCTTB-MOD only
Step 4: Secure modesty panel Mto base kit Nusing (4) wood screws C
Step 5: Flip the base onto the backside of the worktop Las shown in image
Step 6: Secure the base kit N to the work top Lwith (4) worktop bolts G
Step 7: Secure the lever to the work top Lwith (3) wood screws C
LEVER
LUNE TRAINING TABLE
TELESCOPIC SUPPORT BAR
Model Number : FCTTB or FCTTB-MOD
INSTALLATION MANUAL

Step 8: Fold the base kit N by pulling on the lever.
Step 9: Secure the base kit N to the work top L with (4) work top bolts G
Step 11: Secure cords with cord clip O, and cap o leaver with leaver cap IStep 12: Turn table right side up
Step 13: Check all 4 casters lock properly
Step 14: Check the flip top mechanism works properly
Completed Installation:
1980 West Avenue, 140th, San Leandro CA 94577 TEL: [phone] http://www.friant.com 1.09.23