FURNITUREBOX OXFORD BEDSIDE TABLE User manual

OXFORD
BEDSIDE TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/oxford-bedside
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 2
Connect the end pieces [1] to the
cross bars [2] using 2 x washer [C]
followed y 2 x screw [A] in each
corner. Tighten with Allen Key [D].
STEP 1
Use a clear, at, soft
surface to avoid bumps or
scratches.
First assemble the
bottom chrome frame.
Set out the end pieces [1]
and cross bars [2] as per
the diagram and align the
holes.

www.furniturebox.co.uk
STEP 3
Place the high-gloss drawer unit [3]
upside down on the soft at surface.
Place the chrome frame onto the
drawer unit [3] and align the holes.
Connect the chrome frame to the
drawer unit using 2 x washer [C] and
2 x screw [B[ on each side. Tighten
with Allen Key [D].
STEP 4
ATTENTION: Carefully ip the
bedside table the correct way up so
it stands on its chrome legs.
Attach drawer pull handle [4] to the
front of the drawer using 2x screws
[E]. Tighten with Allen Key [D].
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.