FURNITUREBOX ADLEY User manual

ADLEY
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/adley
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
45 MINUTE
BUILD
MAXIMUM
CAPACITY 100Kg

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clean, at, soft surface to
avoid any bumps or scratches.
Cross the legs [3 and 4] as
shown.
STEP 2
Connect the legs. Use
1 x washer [D] followed
by 1 x bolt [A] for the
single hole at what will
be the bottom of the
table.
Use the X shaped
connecting plate [F]
and align with holes in
the table legs. Connect
using 1 x washer [D]
followed by 1 x screw
[B] per hole and tighten
fully with Allen key [G].

www.furniturebox.co.uk
STEP 3
Carefully place the table
top [1] face down on at
surface and align table
legs with holes as shown.
Connect using 1 x washer
[D] followed by 1 x bolt
[C] and tighten with
Allen key [G] -ensure
these are fully tightened.
FULL ASSEMBLY INSTRUCTIONS
STEP 4
Place the shelf [2] between
the table legs as shown.