Geberit IMPULS380 User manual

170.543.00.0
1a. 1b.
2a. 2b.
注意:必须安装过滤网,并且定期清洗。
6L
6L
吉博力产品安装指导说明书-“Impuls380”
进水阀无补水
Geberit Product Installation-inlet valve
“Impuls380”without rell
将进水阀卡入溢流管上部的固定架内；将进水
管的接头套上封水垫圈,插入进水孔,并拧紧安
装螺母，之后装入过滤网。
旋转调节杆以调整工作水位，顺时针方向水位升
高，反之降低；确保工作水位到溢流管顶部的距
离不小于2cm。
将进水阀固定在溢流管上部的固定架内,然后将
进水阀的软管接头与进水管的螺母装配好，注意
装好密封圈和过滤网。
旋转调节杆以调整工作水位，顺时针方向水位
升高，反之降低；确保工作水位到溢流管顶部
的距离不小于2cm。
Fix the filling valve into the fixation frame;
Assemble a seal on screw connector, insert
it to water inlet hole and fastenthe nut then
to be fixed with a filter.
Turning regulation pin in lockwise can adjust
working level, the water level will rise and vice
versa. Assure the minimum distance between
working level to the overflow top not less than
2cm.
Assemble the filling valve into the filling valve
fixation above the overflow pipe. Then assemble
the mental flexible pipe and connector nut.
Advert to assemble the seal and the filter.
Turning regulation pin in lockwise can adjust
working level, the water level will rise and
vice versa. Assure the minimum distance
between working level to the overflow top not
Please note that the filter must be assembled and it should be cleaned regularly.

170.543.00.0
2 3
456
7
10
8
11
9
12
1旋开螺母，取下进水阀
loose nut and take out the valve
转动密封组件
turning the seal set
取出密封组件
take out the seal set
清洗压水腔及膜片组件
clean the closing cap and membrane
装入密封组件
insert the seal set
旋紧密封组件
fasten the seal set
将调节杆与摇臂连接
connect the regulation pin and lever
装入进水阀并旋紧螺母
insert the valve and fasten the nut
恢复原工作水位
readjust the working level
将调节杆与摇臂分开
separate the regulation pin and lever
装配压水腔及膜片组件
assemble the closing cap and membrane
装配膜片
assemble the membrane
6L
最小距离2cm
吉博力产品安装指导说明书-“Impuls380”
进水阀无补水
Geberit Product Installation-inlet valve
“Impuls380”without rell