
GIRA
Info Leak Sensor
Operating Instructions
Connecting zero-voltage contact
1. Deenergise device
2. Pull off cover
3. Replace blind plug (5) with screwed cable gland (6)
4. Insert cable through gland
5. Connect cable for zero-voltage contact to terminal block (7)
Contact via terminal 2 and 3: Closed in case of alarm
Contact via terminal 1 and 3: Open in case of alarm
6. Tighten gland
7. Screw on cover
Alarm test
•Immerse sensor in water.
•ÖLED alarm (3) red and acoustic signal.
•Dry sensor following contact with liquid.
Technical data
Power supply: 230 V AC / 50 Hz / 1.2 VA
Ambient temperature: 0 - 60 °C
Display Operation: LED green
Alarm: LED red and acoustic signal
Zero-voltage contact: AC 230 V/1,800 VA
DC 100 V/300 W
Construction: Polyester housing IP 65
Protection class: II (protective insulation)
Dimensions: 110 x 75 x 55 mm
Connection cable length: 1.5 m
Sensor cable length: 2 m
Directives/Standard
EC EMC Directive 89/336/EEC
Leak Sensor 08/96 Page: 2 of 3