Heat & Glo LOGS-750TRS-E User manual

Heat & Glo • LOGS-750TRS-E • 2120-945 • 3/11
Log Set Assembly: LOGS-750TRS-E
Model: SL-750TRS-IPI-D, SL-750TRS-IPI-E
SL-750TRSFHHIPI
LOG PLACEMENT
INSTRUCTIONS
STEP 1.
CAUTION: Logs are fragile, handle with care.
Carefully remove the logs from the packaging.
STEP 2.
LOG #1 (SRV2117-701) Place log #1 on left flat side of
the burner assembly. Pull the log forward and slide it to
the right until the notches under the log are in the burner
grooves.
STEP 3.
LOG #2 (SRV2120-702) Place log #2 on the grate bar
and push it back against refractory. The pilot should be
centered within the large notch on log #2.
1
1
2
2
3
3
4
4
5
5
1
1
2
2
1
1
LOG NOTCHES
LOG NOTCHES
NOTCH FOR PILOT
NOTCH FOR PILOT
FLAT AREA FOR LOG #4
FLAT AREA FOR LOG #4
Figure 1.
Figure 2.

Heat & Glo • LOGS-750TRS-E • 2120-945 • 3/11
STEP 4.
LOG #3 (SRV2120-703) Place log #3 on right flat side of
burner assembly. The notch on the log should fit over the
bar on the far right side of the grate. Push the log back
against the grate tab.
STEP 5.
LOG #4 (SRV2120-704) Place log #4 so that the right
end sits in the notch or flat spot of log #2. The left end of
the log will sit on the left grate tine and also contact the
vertical portion of the grate tine as shown in Figure 4. The
“burned” part of the log should be pointed downward.
STEP 6.
LOG #5 (SRV2117-705) Place log #5 on log #2. Log #5
will mate with the flat areas located on the top side of Log
#4. See Figure 5.
1
1
2
2
3
3
4
4
2
2
1
1
2
2
3
3
5
5
3
3
4
4
1
1
NOTCH
NOTCH
Figure 4.
Figure 5.
NOTCH
“BURNED” PORTION
POINTS DOWNWARD
Figure 3.
MATE WITH FLAT AREAS HERE
NOTCH