Heat & Glo LOGS-350TRS-D User manual

Heat & Glo • SL-350TRS-E Log instructions • 2113-935 Rev. D • 1/09 1
CAUTION: Logs are fragile. Log #1 (SRV2113-701): Locate the slot on the bottom right side of log 1. Mate the slot with the
right rear log tab. Pull the front left nose of log #1 forward until it touches the left rear log tab.
Log Set Assembly: LOGS-350TRS-D
Models: SL-350TRS-D, SL350TRS-IPI LOG PLACEMENT INSTRUCTIONS
Left rear log tab
Left rear log tab
Lava rock retainer
Lava rock retainer
Grate tine (4)
Grate tine (4)
Log #2 (SRV2113-702): Locate the notch at the left end of
log # 2. Mate the notch with the tine as shown above. The
top end of log #4 should rest on the groove that is located
on the top of log #1. Swing the center branch toward the
burner (see above).
1
1
Mate slot with tab
Mate slot with tab
Left rear log tab
Left rear log tab
Groove used to locate log # 2
Groove used to locate log # 2
2
2
Mate log with tine
Mate log with tine
Mate log with groove on log # 1
Mate log with groove on log # 1
Tip should touch log # 2
Tip should touch log # 2
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
Figure 5
Right rear log tab
Right rear log tab
Shoulder screw
Shoulder screw
Swing branch towards burner
Swing branch towards burner
Groove used to locate log # 3
Groove used to locate log # 3
Log # 3 should rest on log # 1
Log # 3 should rest on log # 1
Mate “Y” with groove
Mate “Y” with groove
Log #3 (SRV2113-704): Locate the “Y” end of log # 3. Mate
the“Y”endwith thegroove onlog #2 (seeabove illustration).
Log # 3 should rest on log # 1, as shown above. The tip of
log #3 should touch log # 2.
3
3
Note: Figure 1 illustrates the recommended gap between the
burner and the lava rock retainer.
Figure 1
3/8 in.
Burner
Lava rock
retainer
No lava rock
may be placed
past this edge.

Heat & Glo • SL-350TRS-E Log instructions • 2113-935 Rev. D • 1/092
Figure 6
Figure 6
Mate shoulder screw with notch
Mate shoulder screw with notch
Log #4 (SRV2113-703): Locate the notch on the bottom of log # 4. Mate the notch with the shoulder screw that is located on the
burner top. Mate the rear groove with the far right grate tine as shown above. Apply the supplied lava rock as shown above.
4
4
Mate groove and grate tine
Mate groove and grate tine
Lava Rock
Lava Rock
Figure 7
Figure 7