Heat & Glo LOGS-Cerona36 User manual

Heat & Glo • CERONA-36 • 2106-935 Rev. B • 7/06
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
LOG PLACEMENT
INSTRUCTIONS
Log Set Assembly: LOGS-Cerona36
Model:Cerona-36
CAUTION: Carefully remove the logs from the packaging.
Logs are fragile!
STEP 1. LOG #1 (SRV2106-701): Place the notch on the left underside of log #1, over the log tab that is located on
the right side of the pilot bracket (B). Move the right end of log #1 forward until it hits the stick on the burner (A). The closer
the log is to the burner the more glow you will get. Don’t place the log too close to the burner or sooting may occur.
STEP 2. LOG #2 (SRV2106-703): Fit log #2 on the
top branch of log #1 (A). Rest the formed groove of the
lower part of the log on the grate. It may be necessary to tilt
Log #1 forward to properly engage with Log #2.
11
23
6
12
534
STEP 3. LOG #3 (SRV2106-705): Place the “Y”
portion of the log in the grate tine and rest the log on the
formed portion of log #2.


BA

A
FORMED
GROOVE

Heat & Glo • CERONA-36 • 2106-935 Rev. B • 7/06
STEP 4. LOG #4 (SRV2106-704): Log #4 is form
fitted to the burner. It sits on the middle portion of the burner
as shown. Logs should sit flush to burner with no gaps
betweenlogandburner.
45
STEP 5. LOG #5 (SRV2106-702): Place the right
portion of log #5 on the formed area of log #1. Place the left
side on the grate. Set the notch of the log on the grate.
6
STEP 6. LOG #6 (SRV2106-706): Restbottomnotch
oflog#6 on the gratetineand the top part on formedsection
of log #5 (A).

A