HIK VISION DS-19A Series User manual

Title:
DS-19A Series white list
configuration
Version:
v1.0
Date:
2018/08/07
Product:
Intrusion Alarm
Page:
1 of 4
DS-19A Series white list configuration
Operating process (configuration process)
1) Confirm Security Control Panel model support GPRS
2) Configuration white list in 4200
3) Test the result
Operating Steps (configuration steps)
1. Confirm the Security Control Panel model is 19XXX-XXG，confirm the
control panel have GPRS module。DS-19A08-01BNG for example，Put the
mobile SIM card in the card slot shown below：
Figure 1:SIM card slot figure
2. In 4200 client remote configuration, network, white list, enable the white list,
add the SIM card number, set the operate permissions and interval time,
as the following figure.

Title:
DS-19A Series white list
configuration
Version:
v1.0
Date:
2018/08/07
Product:
Intrusion Alarm
Page:
2 of 4
Figure 2:White list configuration
【ID】：The drop-down menu has 6 ID，support 6 SMS contact, Each SMS
contact only corresponding to one SIM card number；
【SIM card number】：SMS contact SIM card number；
【Identical Message Interval time】：Same content text messages sent to the
corresponding contact interval time, interval time of 0-5999s;
【Arming/Disarming/Alarm Clearing Permission】：Contacts permissions
configuration；
【Zone alarm Report/ Non-Zone alarm Report】：Set the content of sending
message。
Steps:
1) Enter the whitelist configuration interface.
Remote Configuration->Network->Configure Whitelist
2) Select the index of the whitelist.
3) Check the Enable checkbox to enable the configuration.
4) Enter the phone number of the whitelist into the SIM Card Number text box.
5) Select the identical message time interval that represents the interval of
sending message triggered by the same event.
6) Select the permission of the whitelist on the permission panel.
7) Click Save to save the settings.

Title:
DS-19A Series white list
configuration
Version:
v1.0
Date:
2018/08/07
Product:
Intrusion Alarm
Page:
3 of 4
：
White list of SMS contacts through to send message to SIM card to remote
control the panel, such as Arming, Disarming, Clearing.
Arming command：121#Partition number（Three digits）#
Disarming command：120#Partition number（Three digits）#
Clearing command：100#Partition number（Three digits）#
Example : Partition 1 Arming:121#001#
3. Test results, using mobile phone to send arming/disarming command, then
will receive message of Arm/Disarm success.
Figure 3:Mobile phone message
Table 1：White list Suitable
Model
DS-19A08-BN(G)
DS-19S08-04BN(G)
DS-19A16-BN(G)
DS-19S16-04BN(G)
DS-19A08-01BN(G)
DS-19A08-F/Kx(G)
DS-19S08-04F/Kx(Gx)
DS-19S08N-04F/Kx(Gx)

Title:
DS-19A Series white list
configuration
Version:
v1.0
Date:
2018/08/07
Product:
Intrusion Alarm
Page:
4 of 4
First Choice for Security Professionals
HIKVISION Technical Support