hygena Amparo 600/1443 User manual

Amparo Table
Dimensions
Width - 85cm
Length - 85cm
Height - 76cm
Important – Please read these instructions fully before starting assembly
Assembly Instructions - Please keep for future reference
Issue 4 - 7/09/16
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
600/1443
600/6527
600/6352
600/6541
144/7569
259/3807
621/5136

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

Table leg x 4
(74 x 19cm)
Components - Panels
Please check you have all the panels listed below
2
Table top (85 x 85cm)
2
Components - Fittings
Please check you have all the fittings listed below
17mm Bolt x 16
A
Nut x 8
B
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
1Connecting plate x 4
(10 x 10cm)
3
C
Wrench x 1
Hex Key X 1
D
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105

Assembly Instructions
Assemble table top
Place table top 2
upside down on a clean,
flat surface.
Fix connecting plate 3
onto the table top using
bolts Aby using Hex key
D
Note: The direction of
the arrows should be
pointed outward as
shown in the figure.
Step 1
A
A
A
A
3
2
3
3
3
BB
Assemble legs
Position leg 1over the
connecting board and
secure using nuts Bby
using wrench C.
Note: Make sure the
direction of the table
legs is the same as
shown in the figure
during assembling.
Assembly is complete.
2
1
1
1
1
Step 2
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800