Iron Age Office CARRUCA RECEPTION DESK SINGLE-D User manual

CARRUCA RECEPTION
DESK SINGLE-D
Assembly Instructions
Thank you for your purchase!
Iron Age Office furniture is uniquely and individually
fabricated. For this reason, your furniture is pre-assembled
and labeled before shipping. Labels are marked on the
underside of the furniture. The furniture is then
deconstructed prior to shipping. Pieces that uniquely
correspond can typically be found on the same pallet.
Assembly is best completed by keeping the pieces that
correspond together. Clear your work area of anything that
could scratch furniture surfaces. If possible, cover your
work area with a clean, soft blanket. Carefully flip
any wooden tops over and inspect the bottom sides
for markings. Match legs, flat brackets, etc.
to the appropriate labels.
If you need further assistance of any kind,
please contact:
Iron Age Office Operations Manager
Henry Dover
678-725-1473 (c)
[e-mail]

HARDWARE
Screws are shown actual size. You may receive extra hardware with your unit.
14-10 LAG BOLT
QTY: 26
SCREEN BOLT
QTY: 4
SCREEN NUT
QTY: 4
LEVELING FOOT
QTY: 4 9/16 Crescent Wrench
15/16 Crescent Wrench
3/8 Hex Drive
#3 Square Drive
Tools Required
1
2
3
4

PARTS
MAIN TOP
RIGHT TABBED LEG
LEFT TABBED LEG
MAIN SCREEN
1
2
M1
MS1
TRANSACTION SCREEN
TS1
T1
T2
T3
TRANSACTION SIDE TOP
TRANSACTION TOP
TRANSACTION TOP
1
1
MS1
TS1
TS2
T4
T3 T2
M1
T1
TS2 TRANSACTION SCREEN TRANSACTION SIDE TOP
T4

ASSEMBLY
STEP 1
Place wood top face down on a clean surface.
M1
STEP 2
Align legs to wood top
using markings on the underside
of main top. Tabbed legs should be placed
so that tabs are facing each other.
Screw in all legs with
(5) 14-10 lag bolts per leg.
Screw in (5) 14-10
lag bolts in each leg
using a #3 square drive.
STEP 3
Attach screen to front tabbed legs
with (4) screen bolts and (4) screen nuts.
M1
2
1
1
Insert screen bolts into
the front of the screen
through the tabbed legs
with 3/8 hex wrench.
Fasten screen nut
to screen bolt on
backside of screen with
15/16 crescent wrench.
2
3
MS1

ASSEMBLY
STEP 4
Screw in (2) leveling foot in each leg.
Screw in leveling foot
into each leg with
9/16 crescent wrench.
1
2
4
STEP 5
Flip desk to an upright position.
STEP 6
Align transaction screens to main top.
Secure transaction screen
to main top with 14-10
lag bolts using a #3 square drive.
1
TS1
TS2
M1

ASSEMBLY
STEP 7
Align transaction tops to transaction screens.
Secure transaction tops to
transaction screen with 14-10
lag bolts using a #3 square drive.
STEP 8
Enjoy your desk!
CARE INSTRUCTIONS
To care for either wooden or metal surfaces of Iron Age Office products,
gently wipe with a soft cloth dampened with water and a mild dishwashing liquid.
Once satisfied, dry with a soft cloth.
1
T1
T2
T3
T4