Iron Age Office DOVER CONFERENCE TABLE User manual

DOVER
CONFERENCE TABLE
Assembly Instructions
Thank you for your purchase!
Iron Age Office furniture is uniquely and individually
fabricated. For this reason, your furniture is pre-assembled
and labeled before shipping. Labels are marked on the
underside of the furniture. Most furniture is then
deconstructed prior to shipping. Pieces that uniquely
correspond can typically be found on the same pallet.
Assembly is best completed by keeping the pieces that
correspond together. Clear your work area of anything that
could scratch furniture surfaces. If possible, cover your
work area with a clean, soft blanket. Carefully flip
any wooden tops over and inspect the bottom sides for markings.
Match legs, flat brackets, etc.
to the appropriate labels.
If you need further assistance of any kind,
please contact:
Iron Age Office Operations Manager
Henry Dover
678-725-1473 (c)
[e-mail]

HARDWARE
Screws are shown actual size. You may receive extra hardware with your unit.
14-10 LAG BOLT
QTY: 18
LEVELING FOOT
QTY: 8
9/16 Crescent Wrench
#3 Square Drive
Tools Required
1
4
WASHER
QTY: 18
5

PARTS
DOVER BASE
DOVER BASE
MAIN TOP
1
2
M1
M1
1
2

ASSEMBLY
STEP 1
Place both bases face down on a clean surface.
STEP 2
Screw in (4) leveling feet in each base.
Screw in (4) leveling feet into
each base with 9/16 crescent wrench.
4
STEP 3
Flip both bases to an upright postion.

ASSEMBLY
CARE INSTRUCTIONS
To care for either wooden or metal surfaces of Iron Age Office products,
gently wipe with a soft cloth dampened with water and a mild dishwashing liquid.
Once satisfied, dry with a soft cloth.
STEP 4
Align top to bases using markings
on the underside of the top.
M1
STEP 5
Secure top to bases with (9) 14-10 lag bolts
and washers in each base.
1
5
Screw in (9) 14-10 lag bolts
and washers in each base
using a #3 square drive.
Attach washers to 14-10
lag bolts before securing to top.
STEP 6
Enjoy your desk!