Iron Age Office GLENN User manual

GLENN CONFERENCE
TABLE
Assembly Instructions
Thank you for your purchase!
Iron Age Office furniture is uniquely and individually
fabricated. For this reason, your furniture is pre-assembled
and labeled before shipping. Labels are marked on the
underside of the furniture. Most furniture is then
deconstructed prior to shipping. Pieces that uniquely
correspond can typically be found on the same pallet.
Assembly is best completed by keeping the pieces that
correspond together. Clear your work area of anything that
could scratch furniture surfaces. If possible, cover your
work area with a clean, soft blanket. Carefully flip
any wooden tops over and inspect the bottom sides for markings.
Match legs, flat brackets, etc.
to the appropriate labels.
If you need further assistance of any kind,
please contact:
Iron Age Office Operations Manager
Henry Dover
678-725-1473 (c)
[e-mail]

HARDWARE
Screws are shown actual size. You may receive extra hardware with your unit.
14-10 LAG BOLT
QTY: 20
SCREEN BOLT
QTY: 4
SCREEN NUT
QTY: 4
LEVELING FOOT
QTY: 4 9/16 Crescent Wrench
15/16 Crescent Wrench
3/8 Hex Drive
#3 Square Drive
Tools Required
1
2
3
4

PARTS
RIGHT TABBED LEG
LEFT TABBED LEG
MAIN TOP
1
2
M1
SB SUPPORT BAR
SB
1
M1
2

ASSEMBLY
STEP 1
Place M1 top face down on a clean surface.
STEP 2
Align legs using markings on
the underside of the M1 top.
Screw in all legs with
(10) 14-10 lag bolts in each leg.
Screw in (10) 14-10
Lag bolts in each leg
using a #3 square drive.
M1
STEP 3
Align support bar to in between legs.
Secure support bar with (2) screen bolts
and (2) screen nuts in each leg.
Insert screen bolts into
the support bar through the tabbed
legs using a 3/8 hex drive.
Fasten screen nut to screen bolt
on backside of screen using a
15/16 crescent wrench.
1
2
1
SB
1
2
2
3
2

ASSEMBLY
STEP 5
Flip M1 into an upright position.
Enjoy your table!
STEP 4
Screw in (2) leveling feet in each leg.
Screw in 2 leveling feet into
each leg with 9/16 crescent wrench.
CARE INSTRUCTIONS
To care for either wooden or metal surfaces of Iron Age Office products,
gently wipe with a soft cloth dampened with water and a mild dishwashing liquid.
Once satisfied, dry with a soft cloth.
4