Iron Age Office CARRUCA U-SHAPE User manual

CARRUCA U-SHAPE
Assembly Instructions
Thank you for your purchase!
Iron Age Office furniture is uniquely and individually
fabricated. For this reason, your furniture is pre-assembled
and labeled before shipping. Labels are marked on the
underside of the furniture. The furniture is then
deconstructed prior to shipping. Pieces that uniquely
correspond can typically be found on the same pallet.
Assembly is best completed by keeping the pieces that
correspond together. Clear your work area of anything that
could scratch furniture surfaces. If possible, cover your
work area with a clean, soft blanket. Carefully flip
any wooden tops over and inspect the bottom sides
for markings. Match legs, flat brackets, etc.
to the appropriate labels.
If you need further assistance of any kind,
please contact:
Iron Age Office Operations Manager
Henry Dover
678-725-1473 (c)
[e-mail]

HARDWARE
Screws are shown actual size. You may receive extra hardware with your unit.
14-10 LAG BOLT
QTY: 32
SCREEN BOLT
QTY: 6
SCREEN NUT
QTY: 6
LEVELING FOOT
QTY: 8 9/16 Crescent Wrench
15/16 Crescent Wrench
3/8 Hex Drive
#3 Square Drive
Tools Required
1
2
3
4

PARTS
MAIN TOP
RIGHT TABBED LEG
LEFT TABBED LEG
MAIN SCREEN
1
2M1
MS1
BACK RIGHT TABBED LEG
3RETURN TOP
R1
SPLICE PLATE
A
4BACK LEFT TABBED LEG B1 BACK TOP
SPLICE PLATE
B
B1
R1
M1
A
B
MS1
1
2
3
4
SUPPORT BARSB
SB

ASSEMBLY
STEP 1
Place wood top face down on a clean surface.
STEP 2
Align legs to wood top
using markings on the underside
of main top. Tabbed legs should be placed
so that tabs are facing each other.
Screw in all legs with
(5) 14-10 lag bolts per leg.
STEP 3
Attach screen to front tabbed legs
with (4) screen bolts and (4) screen
nuts into screen. Attach support bar
to back tabbed legs with (2) screen
bolts and screens nuts.
Screw in (5) 14-10
lag bolts in each leg
using a #3 square drive.
1
Insert screen bolts into
the front of the screen
through the tabbed legs
with 3/8 hex wrench.
Fasten screen nut
to screen bolt on
backside of screen with
15/16 crescent wrench.
3
2
B1
R1
M1
234
B1
1
M1
R1
MS1
1
2
3
4

ASSEMBLY
B
1
Attach splice plate at
connection using
(6) 14-10 lag bolts.
STEP 4
Screw in (2) leveling feet in each leg.
4
Screw in leveling foot into
each leg with 9/16 crescent wrench.
3
4
1
2
STEP 5
Align splice plates following marking on
backside of the main and back tops.
B
A
M1
B1

ASSEMBLY
CARE INSTRUCTIONS
To care for either wooden or metal surfaces of Iron Age Office products,
gently wipe with a soft cloth dampened with water and a mild dishwashing liquid.
Once satisfied, dry with a soft cloth.
STEP 6
Flip main and and back desks to
an upright postition.
Align return top in between
main and back desks, resting
the top on the
two splice plates.
M1
A
B
B1
R1
Screw in remaining (3) 14-10 lag bolts in each splice plate
on the underside of the return top to secure splice plates.
1
STEP 7
Enjoy your desk!