Iron Age Office FORTIS SINGLE User manual

Thank you for your purchase!
Iron Age Office furniture is uniquely and individually
fabricated. For this reason, your furniture is pre-assembled
and labeled before shipping. Labels are marked on the
underside of the furniture. The furniture is then
deconstructed prior to shipping. Pieces that uniquely
correspond can typically be found on the same pallet.
Assembly is best completed by keeping the pieces that
correspond together. Clear your work area of anything that
could scratch furniture surfaces. If possible, cover your
work area with a clean, soft blanket. Carefully flip
any wooden tops over and inspect the bottom sides
for markings. Match legs, flat brackets, etc.
to the appropriate labels.
If you need further assistance of any kind,
please contact:
Iron Age Office Operations Manager
Henry Dover
678-725-1473 (c)
[e-mail]
FORTIS SINGLE
Assembly Instructions

HARDWARE
Screws are shown actual size. You may receive extra hardware with your unit.
1
2
3
4
14-10 LAG BOLT
QTY: 16
Tools Required
#3 Square Drive
SCREEN BOLT
QTY: 4
SCREEN NUT
QTY: 4
3/8 Hex Drive
15/16 Crescent Wrench
LEVELING FOOT
QTY: 4
9/16 Crescent Wrench

M1
*
1
*
MS 1
2
PARTS
1
2
M1
*
MS 1
LEFT TABBED LEG
RIGHT TABBED LEG
MAIN TOP
STANDARD LEG
MAIN SCREEN

ASSEMBLY
STEP 1
Place wood top face down on a clean surface.
STEP 2
Align legs to wood top
using markings on the underside
of main top. Tabbed legs should be placed
so that tabs are facing each other.
Screw in all legs with
(4) 14-10 lag bolts per leg.
M1
*2
1
M1
1
STEP 3
Attach screen to front tabbed legs
with (4) screen bolts and (4) screen nuts.
Fasten screen nut
to screen bolt on
backside of screen with
15/16 crescent wrench.
Insert screen bolts into
the front of the screen
through the tabbed legs
with 3/8 hex wrench.
Screw in (4) 14-10
lag bolts in each leg
using a #3 square drive.
1
2
MS 1
3
2

ASSEMBLY
STEP 4
Screw in (1) leveling foot in each leg.
*
2
1
4
Screw in leveling foot into
each leg with 9/16 crescent wrench.
STEP 5
Flip desk and enjoy!
CARE INSTRUCTIONS
To care for either wooden or metal surfaces of Iron Age Office products,
gently wipe with a soft cloth dampened with water and a mild dishwashing liquid.
Once satisfied, dry with a soft cloth.