jbc DI User manual

DI
1 TOOL
CONTROL UNIT
Reference Guide
www.jbctools.com

2
DI/1 TOOL CONTROL UNIT
DESOLDERING PUMP
MS-A
DESOLDERING STAND
DR-SA
CONTROL UNIT
DI-2A
Connectable tools: T210, T245, PA, HT, AP, DR and DS.
Connectable modules: MS, MV and MN.
CONTENTS
INSTALLATION / I.E.CONNECTION
Power Cord Socket
WORK
220
time
SLEEP
220
time
HIBERNATION
room
temperature
JBC stations intelligently manage the tool temperature:
Work mode: When the tool is used, pre-set work temperature is 350º C.
Sleep mode: When the tool is in the stand, the temperature goes down to 220º C.
Hibernation mode: After longer periods of inactivity (pre-set i.e 30 minutes), the power is cut off and
the tool cools down to room temperature.
The advantage of this heat management is lifespan increase which ensure low cost of ownership.
HEAT MANAGEMENT
DI
1 TOOL
CONTROL UNIT
Reference Guide

ORIGINAL PIN: 0105
Main menu
Station settings Counters
Tool settings
1 Reset settings
2 Station settings
3 Tool settings
4 Counters
1 Temp unit Celsius
2 Maximum temp 400
0
C
3 Minimum temp 200
0
C
4 Nitrogen mode OFF
1 Plugged hours 0
2 Working hours 0
3 Sleep hours 0
4 Hibernation hours 0
1 Fix one temp -----
2 Temp levels set OFF
3 Sleep delay 0 min
5 Program version
5 Help text OFF
6 Beep ON
7 Change PIN
5 No tool hours 0
6 Sleep cycles 0
7 Desold cycles 0
4 Sleep temp 220
0
C
5 Hibernationdelay 3 0 min
6 Temp adjust O
O
C
Tool DR
Tool DR
Exit
Back Back
Back
3
WORKING
0
c
Tool DR
Power 10%
350
220
Sleep
C
o
Decrease & move down Increase & move up
Tip temperature
% Instant power supplied to the tool
Working tool model
Status
Selected temperature
SELECT key 2 seconds
to enter Menu
SETTINGS
Selection

ENGLISH / WARRANTY
The JBC 2 years warranty, guarantees this equipment against all
manufacturing defects, covering the replacement of defective parts
and all necessary labour.
Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,
postage paid, to the dealer where it was purchased enclosing this,
fully filled in, sheet.
MORE INFORMATION
www.jbctools.com
SERIAL N`
STAMP OF DEALER
DATE OF PURCHASE
0008528/0210
TECHNICAL SPECIFICATIONS
- Temperature selection from 90 to 450°C (±5%).
- Power: 75W.
- Safety transformer, mains separator and double isolation, with temperature protection fuse.
- DI-2A 230V control unit. Input: 230V 50Hz. Output: 24V.
- DI-1A 120V control unit. Input: 120V 60Hz. Output: 24V.
- Total weight of unit: 2 Kg.
- Complies with CE standards on electrical safety, electromagnetic compatibility and ESD protected housing
“skin effect”.
- RoHS compliant.
- Equipotential connector and the tool tip are connected to station mains ground supply for ESD protection.
This product should not be
thrown in the garbage.