Kimball Office Aspire User manual

Tables Assembly Instructions
Aspire®Page 1 of 3
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741646 Revision C-05
Mount Wood Top To
Table Base Understructure
Tools Required
■#4 Hex Driver ■Adjustable Wrench
■Utility Knife ■#3 Allen Wrench
Package Contents
■1 Understructure ■6 Glides or Casters
■2 Worksurface Half ■48 M6 X 16MM Screws
Installation
Note: These instructions provide basic information for
installing wood tops to the base understructure. For safety
purposes and to avoid damage and/or injury, it is
recommended that the wood tops be installed with the base
in the upright position.
1. Make sure understructure is in upright position. Unpack
casters and insert one in each leg. The casters screw in and
can be tightened using the adjustable wrench. (Figure A).
2. Remove all plastic ties securing the folded frame. (Figure B).
3. Unfold frame by pulling outward on outermost legs.
(Figure C).
Figure A Figure B
Figure C
Remove
all
plastic
ties
Remove
all
plastic
ties

Tables Assembly Instructions
Aspire
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741646 Revision C-05
Page 2 of 3
Installation (continued)
4. Fully extend frame. (Figure D).
5. Carefully lift worksurface half onto one side of frame.
Match holes in frame with holes in underside of
worksurface. Attach worksurface to frame using the
M6 X 16MM machine screws. Tighten all screws securely.
(Figure E).
6. Repeat Step 5 to attach other half of worksurface. Tighten
all screws securely. (Figure F).
Figure D
Figure F
Figure E

Tables Assembly Instructions
Aspire
Printed in U.S.A. © 2005 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741646 Revision C-05
Page 3 of 3
Installation (continued)
7. If the center area of the worksurface is uneven when the
table is in the open position, the worksurfaces can be
adjusted with set screws located under and behind the
latches on each side of the table. (Figure G).
8. Check worksurfaces for unevenness. (Figure H).
9. Use the #3 Allen Wrench to adjust set screws up or down
until worksurfaces are flush. (Figure I). Adjust on both sides
of table, if necessary.
Figure H
Figure I
Figure G
Worksurface Adjustment
set screws
(2 on each side of table)
Worksurfaces not flush
Set screws
Raise or lower set screws to
achieve flush worksurfaces
(both sides of table)
Use Allen Wrench
to adjust set screws