Lee & Plumpton InMotion Double Electric 1200 User manual

1
No.127 A/2224 Revision A 08/04/2019
www.leeandplumpton.co.uk
ASSEMBLY INSTRUCTIONS
RANGE InMotion Double Electric
REF: 1200, 1400, 1600, 1800mm Wide.
Read this leaet before
assembly
2 People
Required
FIXINGS
TOOLS REQUIRED BEFORE YOU BEGIN...
• Check you have all the tools and components required
• Keep children and animals away from small parts
• Ensure you have adequate space
• Assemble product on a at, clean surface
• Apply manual handling guidelines when building this item
• Pozi head screwdriver
• 5mm Allen key
• 6mm Allen key
• 10mm spanner
STEP 1
ASSEMBLY INSTRUCTIONS
Attach the foot plates to the legs
and tighten the bolts (7) (nger
tight only).
Item 1
R/0161
Motor Bracket
Qty 4
Item 2
F/0415
M6x20 Pan Posi Bzp
Qty 8
Item 3
F/0663
M8x10 Socket Cap Bolt Bzp
Qty 8
Item 4
F/0664
M8x10 Socket Shoulder Screw
Qty 8
Item 5
A/2219
Cable Clamp
Qty 6
Item 6
F/0453
4x25mm Flange Pozi
Qty 6
Item 7
F/0662
M6x20 Hexagon Bolt Bzp
Qty 18
Item 8
F/0475
3-4 x10g Pan Pozi Bzp
Qty 24
Item 9
F/0591
5x70 Pan Head Bzp
Qty 8
7
Foot Plate

2
No.127 A/2224 Revision A 08/04/2019
STEP 2
ASSEMBLY INSTRUCTIONS
STEP 3
STEP 4
Use the socket cap bolts (3) and
socket shoulder screws (4) to
attach each leg column to a motor
bracket and a rail, taking care to
ensure the rails face the correct
direction in relation to the desk
tops as per the instructions below.
IMPORTANT: There are screw
holes in the rails for cable trays
and these holes must face
the opposite desk top. Please
also ensure that the holes are
positioned as far away from the
underside of the desktop as
possible (as shown).
Using two people, carefully lift a
desktop and lower into position.
Locate the holes through the
rail underneath the desktop and
tighten into place using screws(9).
Repeat steps 3 and 4 with the
second desktop.
3
4
9
2
Attach the motor brackets to the
underside of the desktop using
screws (2).
Repeat steps 3 and 4 with the
second desktop.
Screw holes for cable trays.

3
No.127 A/2224 Revision A 08/04/2019
ASSEMBLY INSTRUCTIONS
CARE AND MAINTENANCE
STEP 6
STEP 7
STEP 8
STEP 5
A.B.
Clean using a damp cloth and mild detergent – do not use abrasive cleaners or bleach.
A. Attach the power pack to the
underside of the desk using
screws (8) (position left or
right).
B. Fix the cable tidy clamps (5)
into position using screws (6).
Screw the control switch to the
underside of the desk using
screws (8) (position left or right).
Finally, tighten the bolts (7) on
the foot plates using a spanner to
ensure the desks are in alignment.
Secure the left and right side
plates into position on the
underside of the desk using
screws (8).
8
8
6
8
Control Switch
Side Plates