Let's Go Aero H01465 User manual

REQUIRED TOOLS: 10mm SOCKET WRENCH WITH EXTENSION,
15/16” SOCKET WRENCH, 17mm WRENCH, 4mmALLEN WRENCH
PARTS LIST
QTY. DESCRIPTION
A2 FLOOR PANEL
B1 SHANK TUBE
C2 CROSS STRAP
D2 SIDE PANEL
E2 END PANEL
F4 L BRACKET
G1 END CAP
H1 NO-MOTION PIN
J1 1/2” LOCK WASHER
K1 COTTER PIN
L1 SPRING NUT
M4 M8 x 25mm CARRIAGE BOLT
N2 M8 x 60mm CARRIAGE BOLT
O6 M8 WASHER
P6 M8 NYLON NUT
Q39 M6 x 20mm SOCKET HEAD BOLT
R39 M6 WASHER
S39 M6 NYLON NUT
T 2 REFLECTOR STRIPS
U1 5/8 FLAT WASHER
STEPS 1 & 2 TOOLS: 4mmALLEN WRENCH, 10mm SOCKET WRENCH with EXTENSION.
A
B
D
E
F
H
J
U
KL
C
M
N
O
P
Q
T
RS
ASSEMBLY FIT
“Assembly t” most parts when building
this product. This means leaving nuts and
bolts slightly loose to allow parts to easily
t together throughout assembly.
G
E
F
Q
RSAA
Q
RS
Build end panel assembly as shown using four [Q, R, S]. Repeat for a second end panel assembly.
Build oor panel assembly as shown using ve [Q, R, S]. Fully tighten nuts and bolts (oor panel assembly only).
NOTE:
ASSEMBLY
FIT
Big Boss Cargo Carrier
300 lbs Capacity Cargo Carrier For 2” Hitches
Part No. H01465

Attach the shank tube [A] to the receiver hitch of your vehicle as shown.
IMPORTANT: FOR SAFETY fully tighten no-motion pin [H].
IMPORTANT: FOR SAFETY be sure to install cotter pin [K].
STEP 3
L
H
K
U
U
J
J
STEP 4
H
AK
RECEIVER
HITCH
A
TOOLS: 15/16” SOCKET WRENCH
P
O
N
M
Attach two side panels [D] onto shank tube [B] as shown
using two cross straps [C], two [N], four [M] and six [O, P].
D
B
D
C
C
NOTE:
ASSEMBLY
FIT
STEP 5
Attach oor panel assembly using ten [Q, R, S].
TOOLS: 4mmALLEN WRENCH, 10mm SOCKET WRENCH WITH EXTENSION.
TOOLS: 17mm WRENCH
NOTE:
ASSEMBLY
FIT
Q
RS
INSIDE,
ALIGN
WITH
HOLE

Q
RS
BG
STEP 6 TOOLS: 4mmALLEN WRENCH, 10mm SOCKET WRENCH WITH EXTENSION.
Attach end panel assembly as shown using eight
[Q, R, S]. Repeat for the second end panel as-
sembly. By hand, insert end cap [G] into shank
tube [B].
IMPORTANT FINAL STEPS:
1. Now that all parts are “assembly tted” into place tighten all nuts and
bolts securely.
2. Peel back and apply Red Reector Strips [T] as shown.
BIGBOSS™ GUIDELINES
The BigBoss™ Cargo Carrier’s maximum load weight is 300 lbs. Always load cargo in center of the carrier be sure that it is secured
from shifting before traveling. Do not exceed this carrying capacity. Do not exceed the receiver hitch manufacturer’s tongue weight rat-
ing.
Do not use this rack and accessories for purposes other than those for which they were designed. Failure to follow the guidelines of the
product’s instructions will void the warranty.

BigBoss HOODie™
Accessory Cover For BigBoss Model Racks
Part No. H01496
ASSEMBLY AND OPERATION
Unfold your BigBoss HOODie and drape over top of your BigBoss Carrier and any stored cargo. Fit the
thick Waist-Band of the HOODie snuggly over the corners of the carrier. Tighten and connect the
adjustable Release Buckle located underneath the hook and loop fastener storm flaps until taut.
Pull the long Support Straps around the underside of the carrier and back to meet at the top. Connect the
Release Buckle and pull tight to secure your HOODie and cargo to the carrier.
Unfold the included DragNet and drape over top the secured HOODie. Fasten all Molded Clips by securing
and evenly spacing them to anchor points located on the underside of the carrier.
PARTS LIST
Qty Description
1 HOODie Cover
1 DragNet Cargo Netting With Clips
HOODie & DragNet devices are a weather-
resistant (not water-proof) cargo protectant
system, and not a cargo restraint.
Be sure to remove your DragNet and
completely loosen and disconnect all
HOODie Release Buckles rst before
removing the HOODie off your cargo carrier
to avoid damage to your product.
WARNING WARNING
Always check that HOODie, DragNet & stored cargo are fully secured to the carrier before transit
to avoid loss or damage to your product & cargo. Multiple tie-down and strap positions are located
along the BigBoss Cargo Carrier for supplemental ratchet and tie-down restraints when necessary.
WARNING
Warranty Statement:
HOODie Cover and DragNet are warrantied to be free of manufacturer defect.
Look through our comprehensive collection of trailer hitches & towing right away.