Before liing, always make sure that the sling’s strap loops are correctly fastened to the sling bar hooks when the sling strap is
extended, but before the paent is lied from the underlying surface.
For safety, load must be applied to all sling bar hooks during the li!
Maximum load: 205 kg / 450 Ibs.
The SlingBar Mini 220 comes in two versions and with the intended use in liing small paents, for example in a Liko™ TeddySling Low Mod 10.
SlingBar Mini 220 (Prod.No 3156005) can be used combined with a Liko ™ mobile li or a Liko ™ overhead li, with xed assembly.
The SlingBar Mini 220 R2R (Prod.No 3156006) version is designed only for Room-to-Room transfers in combinaon with Likorall™ overhead lis,
specied at page 2.
SlingBar Mini 220 complies with the requirements of EN ISO 10535.
Product Descripon
IMPORTANT!
Read the instrucon guide for both the paent li and liing accessories before use. Liing and transferring a person always involves a
certain level of risk. It is important to completely understand the contents of the instrucon guide. The equipment should be used by
trained personnel only. Please contact your Hill-Rom distributor in the event of any uncertaines or quesons.
Assembly
Dierent maximum loads may apply to dierent products on the assembled li system: li, sling bar, sling and any other accessories used.
For the assembled li system, the maximum load is always the lowest maximum load rang for any of the components. Study the markings
on the li and liing accessories or contact your Hill-Rom representave in the event of quesons.
Safety Instrucons
Connues on next page
SlingBar Mini 220
Instrucon Guide
7EN160200 Rev. 1
ENGLISH 2015-08-11
Require, Fixed kit 4, Prod. no. 3308860
NOTE! Shall be assembled by personnel authorized by Hill-Rom!
Applies to following model:
SlingBar Mini 220 Prod. no. 3156005
SlingBar Mini 220 R2R Prod. no. 3156006
(Prod. no. 3156005)
(Prod. no. 3156006)
Fixed assembly to: Likorall™ 242 S overhead li, Golvo™ mobile li and (Viking™ mobile li, Uno™ mobile li)*
Tools required: 1 x 13 mm (1/2 inch.)
1 x 8 mm (5/16 inch.)
Adapter 12 mm, Prod. No. 2016504
See applicable assembly instrucon!
Fixed assembly to: LikoGuard™ overhead li
* An Adapter 12 shall always be installed between the FlexLink and the Slingbar mini 220 to xed assembly of Viking™ mobile li and
Uno™ mobile li, see below
FlexLink
Adapter 12 mm
SlingBar Mini 220