LuxaFlex Wood Essence Blinds User manual

The information and advice included in this brochure has been
prepared with care. However, we are unable to accept responsibility for
the results of or any damage caused during operation.
Luxaflex®Wood Essence Blinds have been developed to capture the
real look of wood and to eliminate any inconsistencies with colour, grain
and pattern that might traditionally be found in real timber. However,
small variations are considered normal, acceptable quality. Precautions
should be taken to reduce exposure to harsh environmental elements,
such as salt air, where regular cleaning maintenance is recommended.
Somfy is a registered trademark of Somfy SAS. © Copyright 2017 Hunter Douglas
[ABN 98 009 675 709]. ® Registered Trade Marks of Hunter Douglas. 18.017.030
C14375_08.2017
luxaflex.com.au
Wood Essence Blinds
Welcome to the
Luxaflex lifestyle
Thank you for purchasing Luxaflex®Wood
Essence Blinds. With proper operation and
care your new blinds will provide years of
beauty and performance. Please review this
instruction booklet thoroughly for operation
and care information.

Care and cleaning
Wood Essence Blinds combine the look of real wood
with the quality and durability of advance technology
that is resistant to discolouration and warping.
Routine maintenance
Dusting
Dust can be easily brushed off using a clean soft
cloth, a feather duster or a vacuum cleaner with
brushattachment.
To dust, tilt slats up and then down, to reach the top
and bottom surfaces.
Spot cleaning
To remove stains, simply wipe with a sponge and
lukewarm water.
LiteRise operation
To tilt the slats:
Simply rotate the wand to tilt the slats from fully closed
to any desired angle.
To lower and raise the blind:
Simply push up using the bottom rail to raise the blind
and pull down on the bottom rail to lower the blind.
Motorised operation
For motorisation information, please refer to SOMFY®,
Merger®or PowerView®product brochure that is
supplied with yourblinds.
Operation
Manual Cord Lock operation
To tilt the slats:
Pull on one of the single cords to tilt the slats in one
direction, and pull on the other cord to tilt the slats in the
opposite direction.
To raise and lower the blinds:
Raise and lower the shade manually and lock in
place with the cord lock. Wind excess cord around
the cleats.
The cord lock has a locking device that holds the
cords in place when they hang vertically down. To raise
or lower the blind, pull the double cords towards the
middle until you hear the cord lock disengage. When the
blind is at the desired height, return the cord to the side
of the blind to re-engage the cord lock.
IMPORTANT: When raising or lowering the blind, the
slats should be in the open position.