OCEE DESIGN DEN SASS-0081 User manual

DEN
St biliser Foot (Full)
SASS-0081
Assembly Instructions

St biliser Foot (Full)
A x1 Inner Pl te M8 Grub Screw B x1 C x4
4mm Allen Key
Components
Tools
DWG No: SASS-0081
Revision:
Dr wn by: CE
Dr wn d te: 13/10/15
St biliser Foot Assembly Instructions

1.
Loosely insert the inner pl te into the st biliser foot.
2.
Loosely insert the 4x M8 grub screws into the 4x M8 tpped holes, le ving few
millimeters of the screw he d protruding.
3.
Insert the Den p nel into the st biliser foot.
4.
Tighten the 4x M8 grub screws to push the inner pl te into the Den p nel to secure it.
This is best done by tightening e ch screw 2x turns in sequence to ensure the pl te is
being pushed in n equ l dist nce by e ch of the screws nd is p r llel to the vertic l
pl te st biliser foot.
DWG No: SASS-0081
Dr wn by: CE
Dr wn d te: 13/10/15
St biliser Foot Assembly Instructions
Den p nel
B
Inner Pl te
A
St biliser Foot (Full)
C
M8 grub screws
(x4)
4mm llen key