OCEE DESIGN SASS-0102 User manual

Assembly Instructions
Den Seat (Single Module)
SASS-0102

Seat | Back Rest
45
C x1 M6 x 45mm Bolt Q x6
Seat | Pad
B x1
Seat Components
Seat | Base Box
A x1
DEN Seat Assembly Instructions DWG No: SASS-0102
Revision: -
Drawn by: CE
Drawn date: 03/12/15
30
30mm Washer
R x6
ools
4mm Allen Key/Phillips Screwdriver Bradawl (or similar, see step 01)

03.
Fix the sides of the seat base box (A) to the Den shell using 6x M6 x 45mm machine
screws (Q) and 6x 30mm washers (R) in the holes marked above. Passing the bolts
(Q) through the washers (R) and holes in the side of the base box (A) into the inserts in
the Den panels.
Q- M6 x 45mm machine screws &
R - 30mm washers
DEN Seat Assembly Instructions
A
A
01.
All inserts are indicated by the circular white stickers, as shown above. Locate the
inserts through the fabric in the holes indicated above and pierce using a sharp pointed
tool such as a bradawl or the end of a screwdriver, in preparation for passing bolts into
inserts.
Alternatively, carefully make a small cross cut (approx 10mm across) using a sharpe knife
over each of the indicated holes.
6x Insert Indicator Stickers
DWG No: SASS-0102
Revision: -
Drawn by: CE
Drawn date: 03/12/15
Q
R
Lower the seat pad (B) onto the base box (A) until it locates into place. (As shown
above)
04.
A
B
02.
Before assembling, make sure that all the levellers are set so that the bottom of the
base box (A) is flush with the bottom of the Den panels (nominally 20mm from the
ground).
20mm
A- Seat | Base Box
Panel
Levellers
A
A

Lower the back rest (C) onto the seat pad (B). (As shown above)
05.
DEN Seat Assembly Instructions
C
06.
DWG No: SASS-0102
Revision: -
Drawn by: CE
Drawn date: 03/12/15