OCEE DESIGN SASS-0090 User manual

Assembly Instructions
Fabric Cable Riser (& Brackets)
A -0090

Cable Riser Bracket (Right)
A x2 Fabric Cable Riser C x1
Components
Cable Riser Bracket (Left)
B x2
DEN Fabric Cable Riser Assembly Instructions DWG No: A -0090
Revision: -
Drawn by: JB
Drawn date: 19/10/15

1.
Roughly locate the cable riser bracket (A) above the modular screw in the panel using the reference dimensions above. Push the cable riser bracket into the joints between the
back panel and the junctions. Then push the bracket down until the slot in the bracket engages fully over the modular screw in the back panel (as shown in the diagram, above
right.)
Tip: To check the bracket is fully engaged over the modular screw in the back panel, pull the bracet back and forth to make sure it does not move. If the bracket can move back
and forth, the slot in the hook-over bracket is not fully engaged on the modular screw.
DEN Fabric Cable Riser Assembly Instructions DWG No: A -0090
Revision: -
Drawn by: JB
Drawn date: 19/10/15
95
620
X
ACable riser bracket
Keyhole plate
(in junction)
Modular screw
(in back panel)
Fully engaged
Bracket on top
of screw
REFERENCE DIMEN ION
2.
Repeat step 1 for the other 1x right hand bracket (A) and 2x left hand brackets (B)
3.
Attach the fabric cable riser (C) onto the 4x brackets (A & B) by lining up the velcro on
the back of the riser with the velcro on the brackets.
A
B
B
A
A
A