Ogawa OG6250 User manual

OG6250
OG6250

OGAWA OG-6250.
OGAWA
Assembly Instructions
The OG-6250 Massage chair arrives in 3 boxes.
Open box 1 and remove all contents. Remove the packing materials. Take the chair out of the box.
Collect all the accessories and put them aside.
2
1
OG62 50F- 2929

Adjust chair position. Use the power cord to connect the chair to the power supply and turn on the power
switch. The chair will go back to home position. Then disconnect the power cord.
3
Remove cotter pins and bolts from the chair base. Locate the two cotter pins and bolts on the chair base.
Locate the cotter pin and bolt on the link rod. Take them off and put them aside.
4
Here is what it will look like after the cotter pins and bolts
have been removed
Here are the cotter pins and bolts you are to remove. Here is what the eight pin connectors look like.Here is what the four pin connectors look like.
Open box 3 with footrest. Move footrest close to the chair. Engage the link rod with footrest joint, and then
insert the bolt and lock with the cotter pin.
5
Connect wires in footrest. Connect both footrest wire connectors and screw the caps tight. Then connect the
air hose.
Caution: After the wire connectors have been connected the cap must be screwed tight.
6

Here is what it should look like with all wires connected.
Fully connect the footrest to the base. Move the footrest close to the chair. Engage the joints of the footrest
and the base. Lift footrest up to align the holes on the joints, then insert the bolt and lock it with cotter pin (that you
had set aside).
7
Open box 2 with side boards. Take out the side boards. Unzip the zippers of the board.
8
Unzip the zippers here.

Attach the side board. Use the two socket hexagon head screw to fix the side board. Then zip the zipper.
11
Hardware. Locate the screw holes.
Attach the side board. Move the side boards close to the chair and connect the air hose.
9
This is what the air hose looks like when connected.
Locate the “clip”Locate the pothooks. Locate the bolt.
Locate the bolt on the rear of theside board and the clip on the backrest.
Engage the bolt into the clip; meanwhile let the pothooks of the side board catch the frame on the base, then slide
the sideboard onto the chair.
10

12 Attach the remote control holder. Remove the screw from the remote control holder. Insert the remote
control holder into the base support, and then lock it with the screw. Now insert the touch pad remote control
into the holder.
Connect the chair to power supply and turn on the power switch. Now your massage chair is ready to go!
13