9
CONVECTION HEATER HNC-2000/HNC-2000TT
INSTRUCTION MANUAL
PRINCIPLES OF SAFE OPERATION
When using electrical equipment always follow basic safety
rules, especially those listed below:
• This equipment is not intended to be used by persons
(including children) with reduced physical, sensory
or mental abilities or a person with no experience or
knowledge, unless it is done under supervision or in
accordance with the instruction manual, handed over
by persons responsible for their safety. Make sure that
children do not play with the equipment!
• The convection heater should only be used as intended
and in accordance with these instructions.
• Before use, the feet should be assembled in indicated
places (do not use the device without assembled feet).
• Beforeswitchingontheheaterreadthemanualcarefully
(keep the instructions for future reference).
• Beforeconnectingtheunit tothepowersupplycheckif
the casing and power cable are not damaged. Should
the device have any visible signs of damage or if there is
suspicion that it might be damaged in an invisible manner
(e.g.ifdevicedropped),itcannotbeused.Donotusethe
devicewhen defectiveor damaged.Regularlycheck the
device to see if there is no damage to the power cord.
• Inthecaseofanydamagetotheheaterorthepowercord,
the convection heater should be denitely left for repair in
a service shop. Such a device cannot be used. You should
not make repairs or exchange the power cord on your
own.
• Beforeconnectingthepowercordintothepowernetwork,
check whether the rated voltage specied on the device is
consistent with the mains voltage (the convection heater
canbepoweredonlywithAC230V,50Hz,throughsocket
with pin/earth pin).
• Otherequipmentshouldnotbeconnectedtothesocket
with the convection heater. Do not use distributors,
extension cords or remotely controlled devices (systems),
time switches, programmers or other devices switching
theheaterautomaticallyorsemi-automatically.
• The convection heater should not be placed directly
below a power socket. Place the convection heater on the
ground (after assembling the feet), on a at surface in a
stable manner protecting the device from falling.
The device should always operate in the upright position.
The power cord must not come in contact with a damp
orhotsurface.Itcannotbetwistedorplacedwithinthe
reachofchildren.Itmustbeplacedawayfromtheheater’s
casing (which is emitting heat). The power cord must
neither be dragged through sharp edges, nor left to jam.
• Do not use the heater in the room with explosive gas,
ammable adhesives, solvents and similar substances.
There are parts inside the device that can be hot during
operation, or that may cause sparking.
• The convection heater must not be immersed in water
oranyotherliquid.Donotexposethedevicetoweather
conditions(rain,sun...). Do notuse theequipment inan
open area, near a bathtub, shower, pool or other water
sources. Do not use in wet or damp environment. The
device must be protected against ingress of water and
otheruids.Thismaycauseelectricshock.Donotoperate
the device with wet or damp hands.
• Do not use the heater near furniture, bedding, clothes,
paper, curtains and other combustible material due to the
risk of those objects getting ignited from the heaters (the
distance between the convection heater and such objects
cannotbelessthan100cm).
• Donotusetheheaterinaroomwithanareaoflessthan
4 m2. The device cannot be installed nor used inside
vehicles.
• Do not coverthe convectionheater.Donotcover,block
orobstructairinletandairoutletgrilles.Donotobstruct
airow to the unit or the outow of hot air. This may cause
overheating of the device or re.
• Do not insert ngers or other objects in the grid of the
device (when the heater is both turned on or o).
• Before changing the location of the convection heater,
set the heating and ventilation switch to “0” position, the
thermostatknobto„Min”anddisconnectthedevicefrom
the power source.
• Donotleavetheheaterunattendedifswitchedon.
• Do not leave children or pets unattended near the
appliance (children and pets are not allowed to touch or
play with the convection heater. During operation the
temperature in the outlet opening is very high).
• When leaving the house, make sure to disconnect the
convection heater from the power source (set the heating/
ventilation switch to “0” position, the thermostat knob
to“Min”,removetheplugfromthesocket).Alwaysunplug
the heater when not used! The plug disconnected by
pulling the power cord.
• The appliance should be kept clean. Do not allow any
objectstogetinsidethedevice.Donotdisassembleand
openthedevice.Thismaycauseelectricshock,reordamage
to the convection heater.
• Thisdeviceisintendedforhomeuseonly.
OPERATION OF THE DEVICE
When connecting the device and during maintenance and
operation of the device adhere strictly to the safety rules
described in this manual, in the “Principles of safe operation”
section. Place the convection heater in a proper place
(inaccordancewiththesafetyrules).Makesurethatallmode
switches are set to the “0” position and that the thermostat
knob isset to“min.”position. Plugthe heater’scordto the
power source. Set the mode switch to the desired mode of
operation:
UK