Prevue Hendryx Penthouse Suites User manual

Penthouse Suites
Decorative Bird Cage & Stand—Assembly Instructions
Model #261
Included Parts:
1 Ea—Wire Cage Front Panel/Right Side Panel Section
1 Ea—Wire Cage Back Panel/Left Side Panel Section
1 Ea—Wire Stand Shelf
1 Ea—Wire Pull Out Grill 1 Ea—Base Tray
2 Ea—Perches 1 Ea—Cage Base
1 Ea—Wire Cage Roof 4 Ea—Plastic Stand Clips
2 Ea—Cups with Hoods 4 Ea—Wire Stand Legs
Prevue Pet Products, Inc. www.prevuepet.com Email: [email protected]
Step #1: Assemble Cage Stand & Base
•Snap Plastic Stand Clips into place on each of the 4
Wire Stand Legs. Squeeze legs tightly together before
snapping clips into position for a tight “snap” fit.
•Place plastic cage base upside-down onto a table .
•Snap 4 wire stand legs into bottom of Plastic Cage
Base. Place metal plate of stand leg under snap lip of
base (closest to center of base), then use your finger to
slightly pull back the plastic tab on the outside corner
of the base bottom (labeled “Release”). Cage leg will
snap into place. See Illustration #1 & #2
Illustration #1 Illustration #2

•Place the black Wire Cage Roof onto the top of the assembled cage body, and use the
outward facing “U” hooks on the cage body to secure the roof into place.
(Hook the right side of the roof on first, then gently pull it up and over and hook it onto
the top of the left side panel. Then gently pull the back of the roof down & over the
hooks on the top of the back panel. Repeat the same step for the front of the roof).
•Crimp down on the hooks to secure all cage components.
Step #3: Assemble Cage Accessories
•Assemble both parts of each of the 2 feed/water cups, and place into position in the
feeding cup doors on the front of the cage.
•Slide the Wire Pull Out Grille into the cage base above the drawer.
•Place Perches into any desired location inside the cage body from left to right.
Your cage is now ready to use and enjoy……….
Step #1: (Continued)
•Turn Base/Leg assembly right-side-up, so that the legs are supporting the base.
•Put the Wire Stand Shelf into place, with the wire ends of the Shelf going through the 2
holes on each of the 4 Plastic Stand Clips on the Stand Legs
Step #2: Assemble Cage (Separately from Cage & Stand Unit)
•Unfold Wire Cage Main Body, which is in 2 separate sections. One section consists of
the cage front panel (with the front door & cup doors) and the right side panel. The
other section consists of the cage back panel and the left side panel.
•Hook the left side panel onto the cage front panel; use the 4 hooks along the main part of
the panel first, then attach the last hook at the very top corner of the panels.
•Hook the right side panel onto the cage back panel; use the 4 hooks along the main part
of the panel first, then attach the last hook at the very top corner of the panels.
•Now the entire cage body mesh is assembled, with the U hooks along the tops of all
panels facing outward. There are 4 hooks along the tops of cage front & cage back
panels, and 2 hooks along the tops of the left and right side panels.
Prevue Pet Products, Inc. www.prevuepet.com Email: [email protected]
Penthouse Suites
Decorative Bird Cage & Stand—Assembly Instructions
Model #261