protech PPC-7500F User manual

USER’S
MANUAL
PPC-75
0
0
F
Intel®CeleronM
10.4”PanelPCSystem
PPC-7500F M1

Copyright Notice
PPC-7500F Panel PC System
With LCD / Touch screen
OPERATION MANUAL
COPYRIGHT NOTICE
This operation manual is meant to assist users in installing and setting up the
system. The information contained in this document is subject to change
without prior any notice.
This manual is copyrighted April, 2006. You may not reproduce or transmit
in any form or by any means, electronic, or mechanical, including
photocopying and recording.
ACKNOWLEDGEMENTS
All trademarks and registered trademarks mentioned herein are the property
of their respective owners.
CE NOTICE
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.

Copyright Notice
FCC NOTICE
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
You are cautioned that any change or modifications to the equipment not
expressly approve by the party responsible for compliance could void your
authority to operate such equipment.
* All information contained in this document is subject to change without prior notice.
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
WARNING! Some internal parts of the system may have high electrical voltage. And
therefore we strongly recommend that qualified engineers can open and disassemble the
system.
The LCD and touch screen are fragile, please handle them with extra care.

Contents
TABLE OF CONTENTS
CHAPTER 1 INTRODUCTION
1-1 About This Manual ....................................................... 1-2
1-2 Case Illustration ............................................................. 1-3
1-3 System Specification ..................................................... 1-4
1-4 Safety and Notification ................................................... 1-9
CHAPTER 2 SYSTEM CONFIGURATION
2-1 Jumper & Connector Quick Reference Table ............... 2-2
2-2 Component Locations ................................................... 2-3
2-3 How to Set the Jumpers ................................................ 2-4
2-4 COM 1 RI & Voltage Selection ………………….….. 2-7
2-5 COM 2 RI & Voltage Selection ……………………… 2-8
2-6 COM 3 RI & Voltage Selection ……………………… 2-9
2-7 COM 4 RI & Voltage Selection ……………………… 2-10
2-8 RS232/422/485 (COM2) Selection …………..….…… 2-11
2-9 Brightness Voltage Selection ………………………. 2-12
2-10 LVDS Voltage Selection ………………………….…… 2-13
2-11 LVDS Panel Resolution Selection ……………………. 2-14
2-12 Clear CMOS Selection ………………………………… 2-15
2-13 Watchdog Reset/NMI Selection ……………………… 2-16
2-14 CPU_VCCA Voltage Selection ………………………. 2-17
2-15 CPU Frequency Selection ……………………………. 2-18
2-16 COM Port Connector ………………………………… 2-19
2-17 VGA Connector …………………………………….. 2-21
2-18 LVDS Connector …………………………………… 2-22
2-19 Power Connector ……………….……………………. 2-23
2-20 Hard Disk Drive Connector ………..…………………. 2-24
2-21 Printer Connector ……………………………………… 2-25
2-22 LAN Connector ………………….……………………. 2-26
2-23 LAN LED Connector …...…………………………….. 2-26
2-24 Keyboard Connector ………………………………….. 2-27
2-25 PS/2 Mouse Connector ………………………………… 2-27
2-26 HDD LED Connector ………………………………….. 2-28
2-27 Power Button ………………….…................................ 2-28
2-28 Power LED Connector ………………………………… 2-28
2-29 Universal Serial Bus Connector ………………………. 2-29
2-30 Memory Installation ............……….............................. 2-31

Contents
2-31 Inverter Connector …………………………………… 2-31
2-32 Power Module ………………………………..………. 2-32
2-33 Compact Flash Connector …………………………….. 2-33
2-34 PC 104+ Connector ……………………………………. 2-34
2-35 CPU Fan Connector …………………………………… 2-35
2-36 System Fan Connector ………………………………… 2-35
2-37 Serial ATA Connector ………………………………… 2-35
2-38 Reset & Speaker Connector …………………………. 2-36
CHAPTER 3 SOFTWARE UTILITIES
3-1 Introduction ................................................................... 3-2
3-2 VGA Driver Utility ....................................................... 3-3
3-3 Flash BIOS Update ....................................................... 3-4
3-4 LAN Driver Utility ........................................................ 3-6
3-5 Sound Driver Utility .............................…..................... 3-7
3-6 Intel Chipset Software Installation Utility …………….. 3-8
3-7 USB2.0 Chipset Software Installation Utility …………. 3-9
3-8 Serial ATA Driver Utility ………………..……..…….. 3-10
3-9 Watchdog Timer Configuration .................................... 3-11
CHAPTER 4 AWARD BIOS SETUP
4-1 Introduction ................................................................... 4-2
4-2 Entering Setup ............................................................... 4-3
4-3 The Standard CMOS Features ….................................. 4-4
4-4 The Advance BIOS Features ….................................... 4-8
4-5 The Advanced Chipset Features ................................... 4-11
4-6 Integrated Peripherals ……........................................... 4-13
4-7 Power Management Setup ……………………………. 4-17
4-8 PNP/PCI Configuration ................................................ 4-19
4-9 PC Health Status …………………………………….. 4-21
4-10 Frequency / Voltage Control ………………………… 4-22
4-11 Load Fail-Safe Defaults ................................................ 4-23
4-12 Load Optimized Defaults .............................................. 4-23
4-13 Password Setting .................................................…...... 4-24
4-14 Save & Exit Setup ......................................................... 4-25
4-15 Exit Without Saving ...................................................... 4-26

Contents
APPENDIX A SYSTEM ASSEMBLY
Exploded Diagram for Hardware Assembly ….……………… A-2
Exploded Diagram for Removing Hook Holder ….……….… A-3
Exploded Diagram for Removing Back Cover ….……..….… A-4
Exploded Diagram for Cut-Out Dimension ………………….. A-5
Exploded Diagram for Rubber Installation …………………... A-6
Exploded Diagram for Whole System ………………………. A-7
APPENDIX B TECHNICAL SUMMARY
Block Diagram ......................................................................... B-2
Interrupt Map ........................................................................... B-3
RTC & CMOS RAM Map ....................................................... B-4
Timer & DMA Channels Map .................................................. B-5
I/O & Memory Map ................................................................. B-6

Page:1-1
INTRODUCTION
This chapter gives you the information for PPC-7500F. It also
outlines the System specifications.
Section includes:
zAbout This Manual
zCase Illustration
zSystem Specifications
zSafety precautions
Experienced users can skip to chapter 2 on page 2-1
for a Quick Start.
CHAPTER
1

Chapter 1 Introduction
Page: 1-2 PPC-7500F USER
′ S MANUAL
1-1. ABOUT THIS MANUAL
Thank you for purchasing our Panel PC. It is an updated system designed to be
comparable with the highest performance of IBM AT personal computers. It
provides faster processing speed, greater expandability, and can handle more
tasks. This manual is designed to assist you on how to make the proper
installation to set up the system. It contains five chapters. The user can use
this manual for configuration according to the following chapters :
Chapter 1 Introduction
This chapter introduces you to the background of this manual, illustration of
the case, and the specifications for this system. The final page of this chapter
indicates some safety reminders on how to take care of your system.
Chapter 2 System Configuration
This chapter outlines the Prox-7500 components' locations and their functions.
In the end of this chapter, you will learn how to set jumper and how to
configure the system for your own needs.
Chapter 3 Software Utilities
This chapter contains helpful information for proper installations of the VGA
utility, LAN utility, Sound utility and Flash BIOS update. It also describes
the function of the Watchdog Timer.
Chapter 4 Award BIOS Setup
This chapter indicates on how to set up the BIOS configurations.
Appendix A System Assembly
This section gives you the exploded diagram for the whole system unit.
Appendix B Technical Summary
This section gives you the information about the Technical maps.

Chapter 1 Introduction
PPC-7500F USER ′ S MANUAL Page: 1-3
1-2. CASE ILLUSTRATION

Chapter 1 Introduction
Page: 1-4 PPC-7500F USER
′ S MANUAL
1-3. SYSTEM SPECIFICATIONS
MAINBOARD (PROX-7500)
zCPU TYPE:
Intel Celeron-M ULV 1.0GHz on board
Auto detect voltage regulator.
zCHIPSET:
Intel 855GME + ICH4
zMEMORY :
DDR Up to 1GB, 1 x So-DIMM Socket
zCACHE :
Depended on CPU
zREAL-TIME CLOCK :
Embedded in Intel ICH4 South Bridge
zBIOS :
PhoenixAward PnP BIOS
4Mbytes with VGA BIOS
zKEYBOARD CONNECTOR :
Mini DIN connector.
Supports PS/2 Keyboard.
zMOUSE CONNECTOR :
Mini DIN connector.
Supports PS/2 Mouse.
zBUS SUPPORT :
One PCI-104