Protech Ppc-7615 User manual

USER’S

MANUAL

PPC-7615/

PPC-7617/

PPC-7619

Intel®Core2Duo/CoreSolo

15”/17”/19”PanelPCSystem

PPC-7615/PPC-7617/

PPC-7619 M2

PPC-7615/PPC-7617/

PPC-7619

Intel® Core Duo/Solo

Panel PC System

With LCD / Touch screen

OPERATION MANUAL

This operation manual is meant to assist both Embedded Computer

manufacturers and end users in installing and setting up the system. The

information contained in this document is subject to change without any

notice.

This manual is copyrighted in November 2009. (Revised Edition:

December 2009). You may not reproduce or transmit in any form or by any

means, electronic, or mechanical, including photocopying and recording.

ACKNOWLEDGEMENTS

All trademarks and registered trademarks mentioned herein are the

property of their respective owners.

CE NOTICE

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

FCC NOTICE

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

You are cautioned that any change or modifications to the equipment not

expressly approve by the party responsible for compliance could void

your authority to operate such equipment.

Contents

TABLE OF CONTENTS

CHAPTER 1 INTRODUCTION

1-1 About This Manual ........................................................ 1-2

1-2 Case Illustration ……………………………………… 1-3

1-2 System Specification ...................................................... 1-6

1-3 Safety & Notification ...................................................... 1-10

CHAPTER 2 HARDWARE CONFIGURATION

2-1 Jumper & Connector Quick Reference Table ................ 2-2

2-2 Component Locations .................................................... 2-3

2-3 How to Set the Jumpers ................................................. 2-4

2-4 COM Port Connector ……..…………………………... 2-6

2-5 COM3/4 RI& Voltage Selection ………………………. 2-8

2-6 RS232/422/485(COM2) Selection ................................ 2-10

2-7 Keyboard and PS/2 Mouse Connector .....................….. 2-11

2-8 Reset Connector ............................................................ 2-11

2-9 Hard Disk Drive LED Connector .................................. 2-12

2-10 ATX Power Button ….................................................... 2-12

2-11 External Speaker Connector .......................................... 2-12

2-12 PLed Connector ……..................................................... 2-13

2-13 Clear CMOS Data Selection ………………………… 2-13

2-14 CPU Fan Connector ………………………………….. 2-14

2-15 System Fan Connector ………………………………… 2-14

2-16 Hard Disk Drive Connector ........................................... 2-15

2-17 VGA Connector …………………..…………………… 2-16

2-18 Serial ATA Connector ………………………………… 2-17

2-19 Universal Serial Bus Connector ……………………… 2-19

2-20 USB & LAN Connector ……………………………… 2-20

2-21 IrDA Connector ………………………………………. 2-21

2-22 ATX Power Connector ………………………………. 2-21

2-23 Sound Connector ……………………………………… 2-22

2-24 CD Audio-In Connector ………………………………. 2-23

2-25 LVDS Connector ……………………………………… 2-23

2-26 Inverter Connector …………………………………….. 2-24

2-27 LVDS Panel Voltage Selection ……………………….. 2-24

2-28 FSB Frequency Selection …………………………….. 2-25

2-29 Power State Selection ………………………………… 2-26

2-30 Reset/NMI Watchdog Selection ……………………… 2-27

Contents

2-31 CF Card Master/ Slave Selection …………………….. 2-28

2-32 TV Out Connector …………………………………….. 2-29

2-33 Memory Installation …………………………………… 2-29

2-34 PCI-Express Card Selection …………………………. 2-30

CHAPTER 3 SOFTWARE UTILITIES

3-1 Introduction …………..........................................…....... 3-2

3-2 VGA Driver Utility ……………………………….…… 3-3

3-3 Flash BIOS Update ..............................................…....... 3-4

3-4 LAN Driver Utility …...........................................…...... 3-6

3-5 Sound Driver Utility …………………………………… 3-7

3-6 Intel Chipset Software Installation Utility …..……..….. 3-8

3-7 Touch Driver Installation Utility ………………….. 3-9

3-8 Watchdog Timer Configuration ……………………….. 3-10

CHAPTER 4 AWARD BIOS SETUP

4-1 Introduction ................................................................... 4-2

4-2 Entering Setup ............................................................... 4-3

4-3 The Standard CMOS Features ………............................ 4-4

4-4 The Advanced BIOS Features ....................................... 4-8

4-5 Advanced Chipset Features ........................................... 4-10

4-6 Integrated Peripherals …............................................... 4-12

4-7 Power Management Setup ............................................. 4-17

4-8 PNP/PCI Configuration …............................................. 4-18

4-9 PC Health Status …….................................................... 4-20

4-10 Load Fail-Safe Defaults ................................................. 4-21

4-11 Load Optimized Defaults .........................................…. 4-21

4-12 Password Setting ……………………………………… 4-22

4-13 Save & Exit Setup ......................................................... 4-23

4-14 Exit Without Saving ………………………………… 4-24

Contents

APPENDIX A SYSTEM ASSEMBLY

Exploded Diagram of PPC-7615 Whole System ....................... A-2

Exploded Diagram of PPC-7617 LCD Panel …………….…... A-4

Exploded Diagram of PPC-7619 LCD Panel ………………… A-6

Exploded Diagram of PPC-7615/PPC-7617/PPC-7619 Packing .. A-8

APPENDIX B TECHNICAL SUMMARY

Block Diagram ........................................................................... B-2

Interrupt Map ............................................................................ B-3

RTC & CMOS RAM Map ........................................................ B-4

Timer & DMA Channels Map .................................................. B-5

I/O & Memory Map ...............................................…................ B-6

Page:1-1

INTRODUCTION

This chapter gives you the information for PPC-7615/PPC-7617/PPC-

7619. It also outlines the System specifications.

Section includes:

zAbout This Manual

zCase Illustration

zSystem Specifications

zSafety precautions

Experienced users can skip to chapter 2 on page 2-1

for a Quick Start.

CHAPTER

Chapter 1 Introduction

Page: 1-2 PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL

1-1. ABOUT THIS MANUAL

Thank you for purchasing our Panel PC. It is an updated system designed to be

comparable with the highest performance of IBM AT personal computers. It

provides faster processing speed, greater expandability, and can handle more

tasks. This manual is designed to assist you on how to make the proper

installation to set up the system. It contains five chapters. The user can use

this manual for configuration according to the following chapters :

Chapter 1 Introduction

This chapter introduces you to the background of this manual, illustration of

the case, and the specifications for this system. The final page of this chapter

indicates some safety reminders on how to take care of your system.

Chapter 2 System Configuration

This chapter outlines the Prox-B531LF components' locations and their

functions. In the end of this chapter, you will learn how to set jumper and how

to configure the system for your own needs.

Chapter 3 Software Utilities

This chapter contains helpful information for proper installations of the VGA

utility, LAN utility, Sound utility and Flash BIOS update. It also describes

the function of the Watchdog Timer.

Chapter 4 Award BIOS Setup

This chapter indicates on how to set up the BIOS configurations.

Appendix A System Assembly

This section gives you the exploded diagram for the whole system unit.

Appendix B Technical Summary

This section gives you the information about the Technical maps.

Chapter 1 Introduction

PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL Page: 1-3

1-2. CASE ILLUSTRATION

Note: When insert this computer into any machine or wall, user should left at lease

5cm space for thermal issue.

PPC-7615

ont

iew Rear

iew

Top View

Bottom View

Side View

Chapter 1 Introduction

Page: 1-4 PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL

PPC-7617

ont View

ear View

Top View

Bottom View

Side View

Chapter 1 Introduction

PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL Page: 1-5

PPC-7619

Front View Rear View

Top View

Bottom View

Side View

Chapter 1 Introduction

Page: 1-6 PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL

1-3. SYSTEM SPECIFICATIONS

MAINBOARD (PROX-B531LF)

zCPU TYPE:

Intel® Core 2 Duo/ Core Solo/ Celeron® M Socket 478 onboard for

65nm CPU (up to 2.16GHz)

Auto detect voltage regulator.

zCHIPSET:

Intel® 945GME + ICH7R (FSB: 533/667MHz)

zMEMORY :

2 x 200-pin DDR2 SO-DIMM. Support DDR II 667 SDRAM up to 4GB.

zCACHE :

Built-in CPU

zREAL-TIME CLOCK :

256-byte battery backed CMOS RAM.

Hardware implementation to indicate century rollover.

zBIOS :

Phoenix-AwardBIOS™ for plug & play function

4Mbytes with VGA BIOS

zKEYBOARD CONNECTOR :

Mini DIN connector.

Supports for AT/PS2 keyboard.

zMOUSE CONNECTOR :

Mini DIN connector.

Supports PS/2 Mouse.

zBUS SUPPORT :

1 PCI-E (x16) Slot (SDVO), Mini-PCI, CF (only available if on IDE device

attached)

Chapter 1 Introduction

PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL Page: 1-7

zDISPLAY :

PPC-7615 15” LCD Panel XGA 1024 x 768

PPC-7617 17” LCD Panel SXGA 1280 x 1024

PPC-7619 19” LCD Panel SXGA 1280 x 1024

zWATCHDOG :

1~255 seconds Watchdog timer selectable w/Reset/NMI.

zSERIAL PORT :

Four high speed 16550 Compatible UARTs with Send / Receive 16 Byte

FIFOs.

COM1, COM3, COM4 (D-Sub Connector) for RS-232;

COM2 for RS-232/422/485;

MIDI Compatible

Programmable BaudRate Generator

zLAN ADAPTER :

Intel® 82573V (10/100/1000 Mbps).

Support Wake-On-LAN function.

zUSB CONNECTOR :

External: 4 USB ports.

Internal: 2 USB ports (one for Touch control board)

zSOUND :

Realtek ALC655. AC’ 97 Codec.

Interface: Line_IN, Line_OUT, MIC_IN

zHARDWARE MONITORING FUNCTION :

Monitor Voltage, CPU temperature & cooling fan speed.

If CPU temperature is over setting the buzzer will send out a warming (only

under DOS system)

Chapter 1 Introduction

Page: 1-8 PPC-7615/PPC-7617/PPC-7619 USER

′

S MANUAL

LCD PANEL

zLCD TYPE :