protech SP-6130 User manual

USER’S
MANUAL
SP-6130/6132/6135/6138
10.4” / 12.1” / 15” / 8.4” Fanless Panel PC
Powered by Intel
®
D2550
With D I/Audio/2LAN
S
P
-
61
3
0/61
3
2/61
35/6138
M
1

SP-6120/6122/6128
10.4”/12.1”/15”/8.4” Fanless Panel PC
COPYRIGHT NOTICE
All trademarks and registered trademarks mentioned herein are the property of their
respective owners.
This manual is copyrighted in Jun. 2014. You may not reproduce or transmit in any
form or by any means, electronic, or mechanical, including photocopying and
recording.
DISCLAIMER
This user’s manual is meant to assist you in installing and setting up the system. The
information contained in this document is subject to change without any notice.
CE NOTICE
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.

Copyright Notice
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
You are cautioned that any change or modifications to the equipment not expressly
approve by the party responsible for compliance could void your authority to operate
such equipment.
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
WARNING! Some internal parts of the system may have high electrical voltage. And therefore
we strongly recommend that qualified engineers can open and disassemble the system. The
LCD and touch screen are easily breakable, please handle them with extra care.

Contents
TABLE OF CONTENTS
CHAPTER 1 INTRODUCTION
1-1 About This Manual.................................................................... 1-2
1-2 System Illustration...................................................................... 1-3
1-3 System Specifications................................................................. 1-11
1-4 Safety Precautions...................................................................... 1-13
CHAPTER 2 SYSTEM CONFIGURATION
2-1 Jumper & Connector Quick Reference Table............................. 2-2
2-2 Component Locations................................................................ 2-3
2-3 How to Set the Jumpers.............................................................. 2-5
2-4 COM Port & Connector……..……………………………........ 2-7
2-5 COM Port Configuration Connector.......................................... 2-8
2-6 RS-232/422/485 (COM2) Selection……..……………………. 2-9
2-7 COM2 Auto Detect Selection……..…………........................... 2-10
2-8 Front Panel Connector…………..…………………………….. 2-10
2-9 USB Port………………………................................................ 2-11
2-10 LAN Port.................................................................................... 2-11
2-11 DVI Port..................................................................................... 2-12
2-12 PWR-IN Connector.................................................................... 2-12
2-13 SATA & SATA Power Connector............................................. 2-13
2-14 Audio Connector........................................................................ 2-13
2-15 Clear CMOS Data Selection...................................................... 2-14
2-16 System Power Selection………………………………….......... 2-14
2-17 LVDS Connector……………………………………………… 2-15
2-18 LVDS Panel Power Connector ……………………………... 2-16
2-19 CFAST Card Slot……………………………………………… 2-16
2-20 CFAST Card Power Connector…………….…………………. 2-17
CHAPTER 3 SOFTWARE UTILITIES
3-1 Introduction................................................................................ 3-2
3-2 Intel Chipset Software Installation Utility…..…….................... 3-3
3-3 VGA Driver Utility.................................................................... 3-4

Contents
3-4 LAN Driver Utility.....................................................................
3-5
3-5 Sound Driver Utility................................................................... 3-6
3-6 Touchscreen Driver Utility……………………………………. 3-7
CHAPTER 4 BIOS SETUP
4-1 Introduction................................................................................ 4-2
4-2 Entering Setup............................................................................ 4-4
4-3 Main……................................................................................... 4-6
4-4 Advanced…………………….........................…....................... 4-7
4-5 Chipset…………….................................................................... 4-21
4-6 Boot..……………….................................................................. 4-27
4-7 Security………………………………………………………... 4-29
4-8 Save & Exit……………………………………………………. 4-30
APPENDIX A SYSTEM DIAGRAMS
Exploded Diagram for SP-6130 System................... A-2
Exploded Diagram for SP-6132 System……….................................... A-6
Exploded Diagram for SP-6135 System…………………............ A-10
Exploded Diagram for SP-6138 System……….................................... A-14
APPENDIX B TECHNICAL SUMMARY
Block Diagram...................................................................................... B-2
Interrupt Map......................................................................................... B-3
DMA Channels Map……...................................................................... B-8
I/O Map................................................................................................. B-9
Memory Map………………………………………………………….. B-12
Watchdog Timer Configuration…………..…………………………... B-14
Flash BIOS Update……………………………………………………. B-16

Page:1-1
INTRODUCTION
This chapter gives you the information for SP-6130/6132/6135/
6138. It also outlines the System specification.
Section includes:
About This Manual
System Specifications
Safety Precautions
Experienced users can skip to chapter 2 on page 2-1
for Quick Start.
CHAPTER
1

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-2
1-1. ABOUT THIS MANUAL
Thank you for purchasing our SP-6130/6132/6135/6138 10.4” / 12.1” / 15” / 8.4”
Fanless Panel PC with DVI/Audio/2LAN, powered by Intel
®
D2550.
SP-6130/6132/6135/6138 provides faster processing speed, greater expandability and
can handle more task than before. This manual is designed to assist you how to install
and set up the system. It contains four chapters. The user can apply this manual for
configuration according to the following chapters:
Chapter 1 Introduction
This chapter introduces you to the background of this manual, and the specifications
for this system. The final page of this chapter will indicate how to avoid damaging this
board.
Chapter 2 Hardware Configuration
This chapter outlines the component locations and their functions. In the end of this
chapter, you will learn how to set jumper and how to configure this card to meet your
own needs.
Chapter 3 Software Utilities
This chapter contains helpful information for proper installations of the VGA utility,
LAN utility, and Sound utility.
Chapter 4 BIOS Setup
This chapter indicates you how to set up the BIOS configurations.
Appendix A System Diagrams
This appendix gives you the exploded diagrams and part numbers of the SP-6130/
6132/6135/6138.
Appendix B Technical Summary
This appendix gives you the information about the Technical maps, Watchdog-timer
configuration, and Flash BIOS Update.

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-3
1-2. SYSTEM ILLUSTRATION
SP-6130
Front View Rear View
228.8
212.8
281.6
160.83
64.4
75
75
M4*4
(For Vista ARM)
Top View
259.6
217.5
200
7.4
10.6
M3 (X3)
Bottom View
LAN1 LAN2 USB DVI COM1
COM2
SIM Card
VCC GND
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-4
Side View
156.8
140.6
68.98
7.4
11
523
36
10.6
31.6
M3 (X2)
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-5
SP-6132
Front View Rear View
253
324
75
75
62
32.8
M4*4
Top View
302
260
217
71 7.4
M3 (Tapping)*3
Bottom View
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-6
Side View
29.2
9
7.4
5
25
M3
(Tapping)*2
140.6
185
235
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-7
SP-6135
Front View Rear View
395
294
75
75
75
42.2
M4*4
Top View
371
217
220
340
74
7.4
M3
(Tapping)*3
Bottom View
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-8
Side View
42.2
7.4
160
270
67
5
12
28
9
M3
(T
apping)*2
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-9
SP-6138
Front View Rear View
252
184.6
75
M4*4
53.8
75
Top View
217
230.4
71
M3
(Tapping)*3
I/O View
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-10
Side View
140.6
166
21
25
7.4
5
9.3
M3
(T
apping)*2
Unit: mm

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-11
1-3. SYSTEM SPECIFICATION
System
CPU Support Intel
®
D2550 processor on board
Chipset Intel
®
NM10
OS Support Windows 7
Memory Support
1 x DDR3 SO-DIMM Socket (up to 4GB)
Drive Bay 1 x 2.5” SATA HDD
Power Requirement DC-in 9~36V
Front Bezel Aluminum
IP65 Front panel only
Wall Mount Type VESA 75
Net Weight 
SP-6130 (SVGA or XGA): 3.11 kg
 SP-6132: 3.55 kg
 SP-6135: 4.96 kg
 SP-6138: 2.69 kg
Dimension (W x H x D) 
SP-6130 : 281.6 x 228.8 x 68.98 mm
 SP-6132: 324 x 253 x 71 mm
 SP-6135: 395 x 294 x 74 mm
 SP-6138: 252 x 184.6 x 71 mm
Certificate FCC/CE
I/O Ports
Serial Port 2 x COM ports, 5V/12V/RI selectable
(COM2 is RS-232/422/485 selectable.)
USB 2 x USB 2.0
DVI 1 x DVI
LAN 2 x LAN (10/100/1000 Mbps)
Audio  1 x Line-out
 1 x MIC-in
Expansion slot  1 x Mini-PCIe slot
 1 x CFast card slot

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-12
Display
LCD Panel Size 
SP-6130: 10.4”
 SP-6132: 12.1”
 SP-6135: 15”
 SP-6138: 8.4”
Resolution (Brighness) 
SP-6130: SVGA (230 nits) or XGA (400 nits)
 SP-6132: XGA (500 nits)
 SP-6135: XGA (400 nits)
 SP-6138: SVGA (450 nits)
Touch Panel Type (ELO) 5W Analog resistive (USB interface)
Environment
Operation Temp. HDD: 0 ~ 45°C (32 ~ 113°F)
CFast card: 0 ~ 55°C (32 ~ 131°F)
Storage Temp. -20 ~ 60°C (-4 ~ 140°F)
Humidity 20 ~ 90%

Chapter 1 Introduction
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 1-13
1-4. SAFETY PRECAUTIONS
Follow the messages below to avoid your systems from damage:
1. Keep your system away from static electricity on all occasions.
2. Prevent electric shock. Don’t touch any components of this card when the card is
power-on. Always disconnect power when the system is not in use.
3. Disconnect power when you change any hardware devices. For instance, when
you connect a jumper or install any cards, a surge of power may damage the
electronic components or the whole system.

Page 2-1
HARDWARE
CONFIGURATION
** QUICK START **
CHAPTER
2
Helpful information describes the jumper & connector settings, and
component locations.
Section includes:
Jumper & Connector Quick Reference Table
Component Locations
Configuration and Jumper settings
Connector’s Pin Assignments

Chapter 2 Hardware Configuration
SP-6130/6132/6135/6138 USER ′ S MANUAL Page: 2-2
2-1. JUMPER & CONNECTOR QUICK REFERENCE TABLE
JUMPER / CONNECTOR NAME
COM Port Connector COM1, COM2
COM Port Configuration Connector JP4, JP7
COM2 RS-232/422/485 Selection JP6
COM2 Auto Detect Selection JP5
Front Panel Connector JP8
USB Port USB1
LAN Port LAN1, LAN2
DVI-I Port DVI1
PWR IN Connector CN_POWER1
SATA & SATA Power Connector SATA1, HDD_POWER1
Audio Connector JAUDIO1
Clear CMOS Data Selection JP2
System Power Connector JP11, JP12
LVDS Connector LVDS1
LVDS Panel Power Connector JP1
CFast Card Slot JCFAST1
CFast Card Power Connector JP3