Razor E125 User manual

E1XX SERIES ON/OFF SWITCH
INSTALLATION INSTRUCTIONS
CAUTION: To avoid potential shock or other injury, turn power switch OFF and discon-
nect charger before removing or installing the batteries. Failure to follow these steps in the
correct order may cause irreparable damage.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
Tools Required: (Not included)
A. Phillips screwdriver
B. Flat head screwdriver
C. 4mm Allen wrench
D. 8mm open wrench
Parts Included: (Figure A)
A. On/off switch
B. 2 - 4mm Allen bolts
Note: For versions E100/E125 v1-40, E150 v1-26,
E175 v19-33) Please use the two shorter 4mm Allen Bolts
provided with the new On/Off Switch if the existing 4mm
Allen Bolts on the deck plate are longer then the 4mm
Allen Bolts included with the new On/Off Switch. Refer to
“Figure B” and Step 1 “Figure 1”.
Figure 1
Figure A Figure B
Figure 2
Step 1
Using a Phillips head screwdriver, remove the four
screws in the front of the deck. Using a Phillips
head screwdriver and 8mm open wrench, remove
the two screws and locknuts in the back of the
deck. Using a 4mm Allen wrench remove the two
hex bolts. Remove deck plate. Keep screws.
Note: If you are having difficulty removing the
screws, use pliers to twist the screw out from the
bottom.
Using Phillips head screwdriver, remove the
screws on the battery bracket and remove
bracket.
Step 2
Phillips head screwdriver
4mm Allen wrench
Phillips head screwdriver on top,
8mm open wrench on bottom
old bolt
new bolt

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Figure 3
Figure 5
Figure 4
Figure 6
Before closing your unit
1. Insert the new on/off switch in battery tray
2. Re-connect the 2 wires from the control module to the 2 bottom prongs on the on/off switch
3. Re-connect the black wire from the charger port to the top (gold color) prong on the on/off switch
4. Place batteries back into battery tray and re-connect batteries to the control module (refer to Figure 6 for
proper positioning of batteries)
5. Re-place battery bracket and secure using same screws removed in step 2
6. Re-attach the deck plate and secure using bolts removed in step 1
ATTENTION: Charge unit at least 12 hours before riding.
Locate the white plastic connector on the battery.
Cut the zip tie and discard it. Disconnect the white
plastic connectors attached to the battery and
control module by depressing the tab.
Using a flat head screw driver, carefully remove
the glue around the on/off switch. Gently press
down on the top of the on/off switch and push
switch out of the battery tray.
Carefully remove the batteries from the battery
tray. Locate the on/off switch and disconnect the
black wire going to the charger port and the 2
wires going to the control module.
Note: When re-installing the batteries in the
battery tray, make sure to place them in position
shown below.
Step 3
Step 5
Step 4
v1 - 6/11