Regency LPFS2121 User manual

Any problems or questions call Regency Office Furniture at 1-866-816-9822
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
LEGACY FAX/PRINTER CABINET • LPFS2121 • INSTRUCTIONS
Organize your parts and hardware. You will need a Phillips head and flat head screw driver and rubber mallet.
Hardware :
A: Cam Pins(14) • B: Cam Covers(14) • C: Small Screw(6) • D: Medium Screws(8) • E: Large Screws(4)
F: Handle Screws(2) • G: Drawer Handle(1)
ABCDEF
Parts :
H: Runner • I: Base • J: Back Panel • K: Sides(2) • L: Suspension Slide(2) • M: Top • N: Drawer Front • O: Drawer Box
STEP 1 : Attach Runner(H) to Base(I) by inserting
dowels into coordinating holes.
STEP 2 : Insert 1 Cam Pin(A) into Back Panel(J).
E
GFigure 1: To open
Cam, point arrow toward
Cam Pin hole. To lock
Cam, turn clockwise.
H I J K L M N
A
I
H
J
O

Any problems or questions call Regency Office Furniture at 1-866-816-9822
LEGACY FAX/PRINTER CABINET • LPFS2121 • INSTRUCTIONS
STEP 3 : Attach Base(I) to Back Panel(J) by inserting
Dowels into coordinating holes and Cam Pin into Cam
Lock. Lock Cams (Figure 1).
STEP 4 : Insert 4 Cam Pins into each Side(K).
STEP 5 : Attach 1 Suspension Slide(L) to each Side(K)
using 2 Medium Screws(D) each.
STEP 6 : Attach both Sides(K) to Base(I) and Back Panel(J)
by inserting Dowel Rods into the coordinating holes and
Cam Pins(A) into Cam Locks. Lock Cams(Figure 1).
I
J
A A A
A
D
K
L
D
I
J
KK
K
NOTE: Black Piece
faces the Front of the
Storage Cabinet.
Front
Back

Any problems or questions call Regency Office Furniture at 1-866-816-9822
LEGACY FAX/PRINTER CABINET • LPFS2121 • INSTRUCTIONS
STEP 7 : Insert 5 Cam Pins(A) into Top(M). Attach
Top(M) to both Sides and Back Panel by inserting Cam Pins
into Cam Locks. Lock Cams(Figure 1).
STEP 8 : Attach Handle(G) to Drawer Front(N) with 2
Drawer Screws(F).
STEP 9 : Attach Drawer Front(N) to Drawer Box(O)
using 4 Large Screws(E). Insert Drawer into Suspension
Slides(L). Finish by attaching Cam Covers(B).
A
A
A
A
A
M
G
N
F F
E
E
E
E
N
O