Regency MADET2540 User manual

Organize your parts and hardware. You will need a hex key for installation.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Adjustable Height Power Desk • MADET2540 • INSTRUCTIONS

MADET2540
Power Desk Manual
Power control
Zero-set:
Please follow these steps for proper initialization.
1. Ensure that all cables are securely fastened away from moving parts.
2. Activate the zero-setting mode, press and hold the DOWN ARROW button for ve seconds. Once initiated,
continue holding the DOWN ARROW button until both legs are in the lowest position (motor stops).
3. Now the Table is “zero-set” and ready to use.
Preset height instructions:
e Power Desk allows four (1-4) height presets.
Begin by using the UP/DOWN ARROW buttons to raise and lower the table to a desired height.
1. Once satised, press the “S” button.
2. Now press a desired number (1-4) preset. e height is now set.
Codes:
rSt - Reset
Requires the table to be “zero-set” using the steps mentioned above.
ER1 or ER2 - Error
When displayed, please follow the steps below:
1. Please check that all cables are connected properly. Consult the Assembly instructions (separate)
for proper connectivity.
2. Unplug the table from its power source to reset the memory.
3. Now “zero-set” the table using the steps mentioned above.
Remarks:
Continuous operation must not exceed two minutes to avoid motor from overheating or “timing-out”. If the
motor does time-out, please unplug and let motor cool for a minimum of two minutes.
If you have any other questions or concerns about your Power Desk,
please contact Regency Customer Service at 866-816-9822. ank you for your purchase!