Regency Kobe MKTRCT4824 Instruction Manual

Kobe T-Base Assembly and Installation
Step 1: Screw 2 Glides/Casters (C) into each T-base
Leg (B).
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
Two people are required for assembly.
(MKTRCT4824, MKTRCT6024, MKTRCT7224, MKTRCC4824, MKTRCC6024, MKTRCC7224)
Parts & Hardware: (Depending on the product, PART C will be 4 Glides OR 4 Casters)
A: Table Top • B: T-base Leg(2) • C: Glides/Casters(4) • D: Screw(16)
ABD
C
B
Step 2: On a clean flat surface, place desired finish of
Table Top(A) face down.
ALIGN THIS CORNER
WITH TABLE TOP
CORNER
9.5”
Step 3: Prepare your Template (INCLUDED) by taping both
template pages to one another on the dashed line.
EXAMPLE
4”
LINE UP TOP EDGE OF SECOND SHEET HERE.
C

IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
STEP 4a: Follow the Assembled Template for Leg Placement. The template for attaching the legs should be aligned
as shown below.
STEP 4b: When T-base Leg is aligned with the template, Mark the four holes on Table top(A).
Leg #1
Leg #2
B
A
NOTE: Edges of template
align with edges of table.
Step 5: Attach the T-base Leg(B) to the Table Top(A)
using 8 Screws(D) per Leg.

4”
LINE UP TOP EDGE OF SECOND SHEET HERE.

ALIGN THIS CORNER
WITH TABLE TOP
CORNER
9.5”