Regency SRDRT2BF User manual

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
SRDRT2BF-LRDDS7135-VRDDS7135- INSTRUCTIONS
You will need 2 person(s) for this assembly.
You will need a Phillips Head Screwdriver and a Rubber Mallet to Assemble.
Hardware :
A: Corner Brackets(6) • B: Small Screws(36) • C: Cam Pins(16) • D: Cam Covers(16)
Reception Desk
Parts :
E1: Right Leg E2: Left Leg • F: Desk Top • G: Transaction Top • H: Modesty
AB C D
E1 F G H
STEP 1 : Screw cam pins(C) into legs(E1&E2).
(5 each.)
C
C
C
C
C
E
STEP 2 : Lay modesty(H) down so the cam locks
face up and connect right leg(E1) to the modesty by
inserting cam pins(C) into locks. DO NOT TIGHTEN
CAM LOCKS YET.
H
E
Fig. 1a
E
CC
C
C
C
Right leg(E1) Left leg(E2)
E2

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
SSP4224-LRDDS7135-LRDRT4724-VRDDS7135-VRDTR4724 - INSTRUCTIONS
You will need 2 person(s) for this assembly.
You will need a Phillips Head Screwdriver and a Rubber Mallet to Assemble.
STEP 3a : Screw 3 cam pins(C) into Modesty(H).
STEP 3b : Attach desk top(F) to modesty(H) and right leg(E1) by inserting cam pins(C) into locks and tightening (See Fig. 1a).
You may need to move the leg’s(E) cam pins(C) out of the locks on modesty(H) from step 2 to t the desk top in snugly.
C C C
H
E
H
E
F
STEP 4a : Attach left leg(E2) by inserting
cam pins(C) into locks and tightening. (See Fig. 1a)
STEP 4b : Attach 4 corner brackets(A) to bottom of desk
with 6 small screws(B) each. Place them in the
locations shown on the image below.
H
E
F
E
AA
AA
STEP 5 : Attach 3 cam pins(C) to transaction top(G) then
attach transaction top to desk by inserting cam pins(C) into
locks and tightening (See Fig. 1a). Secure top to desk by
attaching last 2 corner brackets(A) to the underside of the
transaction top and sides with 6 screws(B) each bracket.
G
C
C
C