Regency Legacy LCTRT12047 User manual

IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
LCTRT12047, VCTRT12047 - INSTRUCTIONS
You will need 2 person(s) for this assembly.
You will need a Phillips Head Screw Driver and a Rubber Mallet to Assemble.
Hardware :
A: Flat Bracket(2) • B: Small Screws(48) • C: Cam Pins(10) • D: Double Sided Cam Pins(2)
E: Cam Locks(12) • F: Dowel Rods(8) • G: Corner Bracket(6)
Parts :
H: Top(2) • I: Stringer • J: Leg(2)
AB C D E F G
STEP 1 : Lay one top(H) down cam locks(E) facing up and
insert 2 double cam pins(D) into locks(E) and tighten.
STEP 2 : Lay second table top(H) down and insert opposite
side of double cam pins(D) into locks(E) and tighten.
H
IJ H
H
H

STEP 3 : 3 screws on each side of gap) Also
insert 6 cam pins(C) and 2 dowel rods(F) to bottom of table top.
STEP 4 : Insert 2 Cam Pins(C) and 2 Dowel rods(F) in each
leg(J).
LCTRT12047, VCTRT12047 - INSTRUCTIONS
You will need 2 person(s) for this assembly.
You will need a Phillips Head Screw Driver and a Rubber Mallet to Assemble.
A
A
C
C
C
C
C
C
FF
STEP 5 : Lay one leg(J) down with cam pins(C) and dowel
rods(F) facing up and connect stringer(I) to leg(J) by insert-
ing cam pins into locks and tightening.
HH
J
J
I

STEP 6 :Connect second leg(J) to the opposite end of the
stringer(I) by inserting cam pins(C) into locks(E) and tighten-
ing.
LCTRT12047, VCTRT12047 - INSTRUCTIONS
You will need 2 person(s) for this assembly.
You will need a Phillips Head Screw Driver and a Rubber Mallet to Assemble.
STEP 7 : Attach 4 corner brackets(G) with 6 screws(B)
each bracket to the 4 corners where the legs(J) meet the
stringer(I).
STEP 8 :
feet are pointed up and insert the cam pins(C) that are at-
tached to table into locks(E) on the legs/stringer and tighten
locks once in place.
STEP 9 : Attach remaining 2 corner brackets(G) with 4
screws(B) each to the stringer(I) and table bottom where the
2 tops(H) come together.
When moving table hold it so you have one hand on each side of the gap where table tops join.
JJ
I
J J
I
G