Regency 9476 User manual

9476 • Assembly Instructions for the 9476 Side Chair
ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE
IMPORTANT NOTICE:
• Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching them.
• Check to be sure that you have all parts and hardware.
• Remove all wrapping materials, including staples & packing straps before you start to assemble.
• DO NOT tighten all screws/bolts until completely assembled.
• Keep all hardware parts out of reach of children.
Any problems or questions? Call Regency at 1-866-816-9822 or email [email protected]
PARTS:
HARDWARE:
F: 2x Legs
A: 2x Small Bolts
E: 1x Assembly Key
G: 1x Seat
B: 4x Large Bolts
H: 1x Seat Back
C: 4x Large Screws
*I: 2x Slats
D: 4x Bracket
*Please note that one slat is shorter than the other. Ensure that the shorter slat gets inserted into the more angled side of
the leg with holes facing inwards.

9476 • Assembly Instructions for the 9476 Side Chair
ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE
Any problems or questions? Call Regency at 1-866-816-9822 or email [email protected]
STEP 1: Insert the Small Slat (I) into angled part of
either Leg (F), with holes facing inwards.
Ensure it is inserted all the way into the leg
STEP 3: Attatch other Leg (F) by aligning the holes
on the legs with the pegs from the Slats (I). Ensure
the leg is pressed down onto the pegs completely.
STEP 4: Attach Seat Back (H) by lining up the
cutouts on the underside of the Seat Back (H) with
the holes on the top of each Leg (F). Secure with
both Small Bolts (A)
STEP 5: Place Bracket (D) into
one of the cutouts in Slat (I)
with open edge facing inwards
STEP 6: Place Large Bolt (B) through Bracket (D) and tighten using
the Assembly Key (E). Repeat STEP 5 & 6 for each one of the 4 total
cutouts on the Slats (I) to secure the assembly.
PUSH
DOWN
STEP 2: Insert the Large Slat (I) into straight beam
of the same Leg (F) as STEP 1 with holes facing
inwards and once again making sure it is all the
way inserted.
PUSH
DOWN
I
I
I I I
I
F
F
F
DB
E
D
H
F A D

9476 • Assembly Instructions for the 9476 Side Chair
ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE
Any problems or questions? Call Regency at 1-866-816-9822 or email [email protected]
STEP 7: Take note of Seat (G) orientation before
placing it onto the Slats (I). There is a sticker that
claries which side is the front of the seat.
STEP 9: Insert Screws (C) into predrilled holes in
bottom of each Slat (I) and tighten.
The completed assembly should look like this.
(Colors may vary based on purchased nsh)
STEP 8: Once the correct orientation is found,
place the Seat (G) onto the chair assembly with the
front side facing away from the seat back.
PLACE
DOWN