Regency LCTRT7135 User manual

Parts:
Quantity: 2
F: Thumb
Screws
E: Flat Bracket
C: Stringer D: EClip Bracket
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Keep all hardware parts and packaging out of reach of children.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
B: Tabletop
Legacy Racetrack Conference Table • INSTRUCTIONS
(LCTRT7135, LCTRT9543, LCTRT12047)
Organize your parts. You may need a rubber mallet.
G: Corner Bracket
Hardware:
Quantity: 2
Quantity: 2
Quantity: 1
Quantity: 2
Quantity: 2
Quantity: 10
Quantity: 1
A: Legs
H: DPEL
A
A
C
B
H

STEP 2: Attach Eclip Brackets (D) to outside of Legs (A) by lining up Eclip with it’s corresponding hole, and sliding down
into place (see Figure 1 above).
STEP 1a: Attach Stringer (C) to one of the Legs (A) by lining up the Eclip with its corresponding holes, and sliding down
into place (see gure 1). Please Note: The interior of Legs(A) have two EClip attachment holes and the exterior has just one.
A
DD
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Figure 1
Legacy Racetrack Conference Table • INSTRUCTIONS
(LCTRT7135, LCTRT9543, LCTRT12047)
Organize your parts. You may need a rubber mallet.
STEP 1b: Attach Stringer (C) to the other Leg (A) (see gure 2) by lining up
the Eclip with its corresponding holes, and sliding down into place (see gure
1.) Please Note: The interior of Legs (A) have two EClip attachment holes.
Figure 2
D
A
A

STEP 4a: From underneath the table, lock both Sash Locks on Tabletops (B) (see gure 3).
STEP 4b: From underneath the table, attach both Flat Brackets (E) and Corner Brackets (G) into pre-drilled holes by
using Thumb Screws (F) (see gures 4 and 5).
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 3: Attach Tabletops (B) to assembled base by lining up pre-drilled holes on bottom with the EClips on Legs (A). Then
slide Tabletops (B) into place from opposite sides. Please note: t will be snug. You may need a rubber mallet to tap into place
B
B
Legacy Racetrack Conference Table • INSTRUCTIONS
(LCTRT7135, LCTRT9543, LCTRT12047)
Organize your parts. You may need a rubber mallet.
OPTIONAL STEP 5: Insert DPEL(H) using provided screws.
Figure 3 Figure 4 Figure 5