Regency MKTBX22 User manual

IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Oce Furniture at 1-866-816-9822
AB
C
D
E
F
GA. Table Top
B. Large Base
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
Square Table Top INSTRUCTIONS
(MKTBX22, MKTBX30, MKTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848)
Step 1: Screw 4 feet (F) into
base (B) leg ends.
Step 2: Remove the nuts from
the rod (E), set the nuts aside.
STEP 4: Place spider down so the spider is ush on oor and rod
is sticking straight up. Insert cylinder (C) over rod so the at side is
touching the spider ush. Then place Large Base (B) into place and
screw bolt to tighten.
Organize your parts. You will need a drill,pencil and crescent wrench. Two people are required for assembly.
Step 3: Insert the rod (E) through
the hole in (D) and attach a nut to
exposed rod end. Have 1/4 inch of
rod extruding
at nut.
STEP 6: Turn Table Upside down .
Draw 2 diagonal lines across the
table bottom from upper right
corner to lower left then lower
right to upper left.
STEP 7: Place dot 1, located on
the template, directly over the
crossing lines.
1
STEP 8: Once aligned punch a
pen through remaining tem-
plate dots 2,3,4,5 and mark
table bottom.
1
2
11
3
45
STEP 10: Line up marks made
on the table from step 8 holes
on spider arms.
STEP 11: Drill in all 8 screws (G)
and ip table over.
STEP 9: Place
table top (A) at
on the oor and
set the
completed base
(H) over the
center.
H
1
2
3
45
2
3
45
1
1

1
-The Outside dots are for 48” Table
tops and MKTBX 36 X-Bases.
-The Inside dots are for 30”, 36” and
42” Table tops and MKTBX 22 & 30
X-Bases.
2
3
4
5