Regency MTBX22 User manual

A BC
D
EF
G
A. Square Top
A2. Round Top
B. Large Base
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
Step 1: Screw 4 feet (F) into base (B) leg
ends.
Step 2: Remove the nut from rod (E) and
set aside.
Step 3: Insert the rod(E) through the hole in
the base (B) and attach nut to exposed rod
end under base bottom.
STEP 4: Next place the cylinder (C) over the
exposed metal rod (E).
STEP 5: Place the exposed end of the metal
rod (E) through the hole in the spider (D) and
twist the second nut back onto the rod until
tight
The product
should now look
like the example
to the right.
Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional).
Two people are required for assembly.
Square/Round Table Top INSTRUCTIONS
(MTBX22, MTBX30, MTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48)
A2

STEP 7: Turn Table Upside down. According to your table top(Square or Round) draw 2 diagonal lines across the table as shown below.
STEP 8: Place dot 1, located on the template, directly over the crossing lines.
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line.
11

IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
STEP 9: Once aligned, mark template dots 2,3,4,5 on table bottom.
1
2
3
45
STEP 11: Line Up the marks made on table from step 9 with the holes on the spider arms. Attach using 8 Screws(G) and flip table over.
STEP 10: Place table top
(A,A2) flat on the floor and
set the completed base
over the center.
1
2
3
45
2
3
45
1
1
2
3
45
1
2
3
45

LINE UP TOP EDGE OF SECOND SHEET HERE.
1
-The Outside dots are for 48” Table
tops and MTBX 36 X-Bases.
-The Inside dots are for 30”, 36” and
42” Table tops and MTBX 22 & 30
X-Bases.
2
3

4
5