Regency ONCSLF7124 User manual

Organize your parts and hardware. You will need (2) people, a Phillips head screwdriver and rubber mallet.
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Parts :
Cam Lock Assembly:
To open Cam, point arrow
toward Cam Pin hole. To
lock Cam, turn clockwise.
Figure 1:
PED-J
PED-I
TT-F LG-F
MP-F
PED-I: Lateral
(35.5” x 23.5” x 24.5”)
Quantity: 1
PED-J: Foot Bracket
(23.5”D)
Quantity: 2
PED-K: Top Bracket
(23.5”D)
Quantity: 2
TT-F: Credenza Top
(71” x 23” x 1”)
Quantity: 1
MP-F: Modesty
(35.5” x 24.5” x 1”)
Quantity: 1
LG-D
LG-E
PED-K
LG-D: Leg
(24.5” x 23.5” x 1”)
Quantity: 1
LG-E: Foot Bracket
(23.5”D)
Quantity: 1
LG-F: Top Bracket
(23.5”D)
Quantity: 1
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
71” Single Lateral Credenza
Page 1

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Hardware :
I: Corner Bracket
Quantity: 2
J: Allen Key
Quantity: 1
K: Wood Cam Pins
Quantity: 2
L: Fine threaded
Cam Pins
Quantity: 2
M: 3/4” Wood Screws
(19mm)
Quantity: 18
O: 3/4” Short Bolts
(19mm)
Quantity: 18
P: 1.5” Long Bolts
(38mm)
Quantity: 12
S: Glides
Quantity: 6
T: Insert Covers
Quantity: 8
Q: Locking Screws
Quantity: 2
Locking Screws
N: Cam Caps
Quantity: 4
Cam Caps
R: 3” Screw/Washers
(76mm)
Quantity: 5
U: Set of Keys
Quantity: 1
NOTE : PRODUCT IS REVERSIBLE.
SOME STEPS INCLUDE BOTH RIGHT AND LEFT ORIENTATIONS.
Please examine all parts before assembly. Hardware placement is critical.
V: Handles
Quantity: 4
W: Washers
Quantity: 6
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
71” Single Lateral Credenza
Page 2

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 1 : HARDWARE PLACEMENT ON LEG(LG-D) DEPENDS ON LEFT LATERAL & RIGHT LATERAL ORIENTATIONS.
PLEASE EXAMINE CAREFULLY.
If you are following the instructions for a LEFT LATERAL
CREDENZA, place your hardware as shown below.
If you are following the instructions for a RIGHT LATERAL
CREDENZA, place your hardware as shown below.
SS
R
R
R
STEP 1A: Insert 2 Locking Screws(Q) into the top of the Leg(LG-D). Attach Leg Top Bracket(LG-F) to Leg(LG-D) by inserting
the Locking Screws(Q) into the slide locking holes on Leg Top Bracket(LG-F). Slide into place. Insert 2 Screw/Washers(R) to
lock bracket in place. Insert 2 Glides(S) into Leg Foot Bracket(LG-E), then attach Leg Foot Bracket to Leg(LG-D) using 3 Screw/
Washers(R). Finish by inserting 2 Wood Cam Pins(K) into Leg(LG-D).
Q Q
K
K
K
K
LG-F
R
R
QQ
SS
LG-E
R
LG-D
(interior side)
LG-D
(interior side)
STEP 2 : Attach Leg(LG-D) to the Credenza Top(TT-F) using 6 Short Bolts(O).
Note: Attach the Leg(LG-D) so that the inserts for a Bridge are toward the front of the Credenza(Figure 2).
Leg(LG-D)
so that the inserts for a Bridge are toward the front of the Credenza
TT-F
O(3)
LG-D
NOTE: Supports
face interior side.
Figure 2
LG-F
LG-E
O(3)
Bridge Inserts Bridge Inserts
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
71” Single Lateral Credenza
Page 3

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 4A : Insert 2 Glides(S) into each Foot Bracket(PED-J).
STEP 4B : Attach each Foot Bracket(PED-J) to the Lateral(PED-I) by placing 1 Washer(W) between the base and each wood
screw hole on the Foot Brackets(Figure 2). Then, insert 6 Long Bolts(P) and 6 Wood Screws(M) to attach to Lateral(PED-I).
S
PED-J
M
P
P
P
P
P
P
M
M
M
M
M
PED-I
PM
PM
PM
W
W
W
PED-J
Figure 2
S
PED-J
STEP 3 : Pull out each drawer and nd the black tabs at the end of the suspension. Lift one side up and press the other side down
simultaneously and pull the drawer out. This will unlock the drawer and release it. Repeat this for all drawers.
STEP 5 : Lateral Component is Reversible. Decide on an orientation(Left and Right). According to the orientation that you choose,
remove 2 Cam Pin Covers in the location shown below. Then insert a Fine threaded Cam Pin(L) into each of the revealed inserts.
L
L
L
L
Right Lateral
Left Lateral
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
71” Single Lateral Credenza
Page 4

STEP 6 : According to the orientation that you choose, attach Top Brackets(PED-K) to Credenza Top(TT-F) using 6 Short Bolts(O)
to attach each bracket. Do not tighten bolts until all are started.
PED-K
TT-F
STEP 7 : Attach Lateral(PED-I) to the Modesty(MP-F) by inserting Cam Pins into Cam Locks. Lock Cams (Figure 1).
PED-K
TT-F
Right Lateral
Left Lateral
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Right Lateral
Left Lateral
STEP 3 : Attach Modesty(MP-F) to Leg(LG-D) by inserting and locking cam pins (Figure 1).
NOTE: Cam Locks face the interior of the Desk. Be sure to support opposite end of Modesty.
LG-D
MP-F
NOTE: Cam Locks face the interior of the Desk. Be sure to support opposite end of Modesty.
LG-D MP-F
Right Lateral
Left Lateral
MP-F
MP-F PED-I PED-I
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
71” Single Lateral Credenza
Page 5

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 9 : For additional stability, attach Corner Brackets(I) to Lateral(PED-I) and the Modesty(MP-F) with 6 Wood Screws(M)
per Corner Bracket. Repeat this step for the Leg(LG-D) and the Modesty(MP-F) connection.
71” Single Lateral Credenza • ONCSLF7124 • INSTRUCTIONS
CARTONS: TT7124, MP3524, PLF3624, LG2824
STEP 8 : Attach Lateral(PED-I) to Credenza Top(TT-F) using 6 Long Bolts(P).
Lateral(PED-I)
Credenza Top(TT-F)
TT-F TT-F
P(3)
Right LateralLeft Lateral
STEP 10A: Flip Credenza upright with at least 2 people. Replace Drawers and attach Handles(V) to the Lateral(PED-I). Finish by
covering all Cam Locks on the Modesty(MP-F) with Cam Caps(N).
STEP 10B : If the cam pin inserts are not being utilized for a bridge connection, cover all cam pin inserts on the Leg(LG-D) with
Insert Covers(T).
PED-I PED-I
P(3)P(3)P(3)
71” Single Lateral Credenza
Page 6