Roger PR402DR User manual

QUICK START GUIDE
Connection and communication of PR402DR access controller
and RFT1000 ngerprint readers.
Typical installation of PR402DR access controller and RFT1000 ngerprint readers
* NOTE! If the system is operated by means of Ethernet port then RS485 bus is not used for communication with RFT1000 readers.
Technical support is available in weekdays:
• from 8:00 am to 4:00 pm at PSTN number [phone]
• from 4:00 pm to 8:00 pm at GSM number [phone]

ROGER sp. z o.o. sp. k.
Gościszewo 59
82-400 Sztum
Poland
T. [phone]
F. [phone]
E. [e-mail]
I. www.roger.pl
Legal Notice
This document is not intended to be a technical specication of the product and has informative character only. The Manufactures of product reserves right
to change its characteristic without notice. The product features listed in this document refer to the entire series and depends on particular product version,
conguration and additional equipment.
RevB © 2020 ROGER sp. z o.o. sp. k. All rights reserved. This document is a subject to the Terms of Use in their current version published at the www.roger.pl
Possible scenarios of operation
1. Communication by means of Ethernet port
2. Communication by means of RS485 port