Sealey AP223 User manual

INSTRUCTIONS FOR
TOOLBOX - TOPCHEST, MID-BOX, ROLLCAB
MODEL NO: AP223, AP225, AP226
AP223B, AP225B, AP226B.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
8DO NOT open more than one draw at a time.
9Close lid, lock draws before moving.
8DO NOT stand on the tool boxes
8DO NOT mount the tool box on a truck bed or any other moving object.
9Apply brakes on swivel casters when not moving unit.
8DO NOT pull the tool box when moving, only push to move.
8DO NOT stand inside the draws.
2. INTRODUCTION
Manufactured from double skin side walls for extra strength and nished in a smooth, hi-gloss triple baked enamel. Resists scratches, oil,
dirt and most solvents. Topchests and mid-boxes feature 35mm ball bearing runners and recessed carry handles. Rollcabs feature 45mm
ball bearing runners, side handle and four castors (two xed and two locking) for mobility around the workshop, even when fully laden. Each
drawer face has full length pulls with chrome style trims. All chests are supplied with tumbler type security locks and two numbered keys.
3. OPERATION
3.1. Topchest.
3.1.1. To lock the tool box. Make sure all draws are closed, close lid,
turn key anti-clockwise.
3.1.2. To unlock the tool box.Turn key clockwise and pull open draw.
3.2. Mid-Box / Rollcab.
3.2.1. To lock the tool box. Make sure all draws are closed, turn key
anti-clockwise.
3.2.2. To unlock the tool box.Turn key clockwise and pull open draw.
8DO NOT slam the draws shut as damage may occur to the
lock bar tabs or lock pockets.
3.3. To remove Draws.
3.3.1. Empty draw and pull out until it stops.
3.3.2. Release the black retaining clips by pushing the righthand side
clip up and the left hand side down simultaneously, and pulling
the draw out g.1.
3.3.3. To re-install draws, place draw onto slides and push in.
3.4. Casters and side handle.
3.4.1. Roll cabinet is supplied with heavy duty castors, including two
swivel castors. Fix as shown in g.2.
3.4.2. The side handle must be xed on the same side as the swivel
castors, by inserting handle through slots in side of cabinet and
xing in place with the four set screws provided.
AP223(B),AP225(B),AP226(B) | Issue 1 27/10/16
Original Language Version
© Jack Sealey Limited
Refer to
instructions
g.1
g.2

4. MAINTENANCE
4.1. Lubricate the top and bottom channels of the drawer slides at
least twice a year.
4.2. If the lock bar tabs or pockets get damaged remove draws
and with pliers or a screwdriver straighten g.3.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [e-mail] or telephone [phone].
g.3
AP223(B),AP225(B),AP226(B) | Issue 1 27/10/16
Original Language Version
© Jack Sealey Limited